A 100 V voltmeter has full-scale accuracy of 5%. At its reading of 50 V it will give an error of
we can find the zero error by closing the jaw of screw guage if the zero of main scale(MS) is concide with the zero of circular scale (CS) there is no zero error and if they are not concide there is a zero error in screw guage .
depending on ur grade scale if its ten point then its C if its not then its a D
6
200 - bdhbjehje
That is just utter nonsense. Kelvin is the absolute scale so percentages should be calculated in Kelvin and not Celsius.
This error depends on the type of your balance; read the error of the balance on the scale, label or user manual.
8.6
The scale displayed a weight that was 7.94% low. (rounded) We say it that way because the percent error may not be constant over the scale's entire range. It was 7.94% at this particular point, but the scale may be more or less accurate at other weights.
A 100 V voltmeter has full-scale accuracy of 5%. At its reading of 50 V it will give an error of
Not if the gradient calculation is done correctly.
if the zero of vernier scale lies on the right side of the zero of the main scale , then error is known as a positive error .
I usually use # of Correct Questions / # Of Total Questions = Percentage Correct
Overload error: This occurs when the weight on the scale exceeds its maximum capacity. Underload error: This happens when the measured weight is below the scale's minimum capacity. Zero error: This is when the balance scale does not return to zero after being unloaded or reset. Eccentricity error: It occurs when the center of mass of the object being weighed is not aligned with the center of the scale.
CGPA 9/10
The zero error of vernier calliper is defined as :-The zero error is equal to the distance between the zero of the main scale and the zero of the vernier scale.
scale