105 mm dia
420-425 mm length
Chat with our AI personalities
105 millimeters is equivalent to 4.13385827 inches. This conversion is based on the fact that 1 inch is equal to 25.4 millimeters. Therefore, to convert millimeters to inches, you would divide the number of millimeters by 25.4.
Traditional Concrete Masonry Unit (CMU) Blocks have 2 rectangular voids through the block. These voids are called "Cells". The face shell thickness is the thickness of the block material from the cell to the front of the block. For example, a typical block of dimensions 8"high by 8"deep by 16" long probably has a face shell thickness of 1.25".
This question cannot be answered sensibly. A square metre is a measure of area, with dimensions [L2]. A tonne is a measure of mass, with dimensions [M]. Basic dimensional analysis teaches that you cannot convert between measures with different dimensions such as these without additional information.
What you are looking for are driven dimensions. Derived dimensions must be a typo. Driven dimensions are enclosed in parentheses to distinguish them from regular dimensions in inventor. These dimensions do not contrain a sketch they simply reflect dimensioned geometry which is most likely under some geometric constraint.
The dimensions are: The dimensions of the square are LW Length x width (srry about the last one)