0
Add your answer:
Earn +20 pts
What careers use graphs?
economists and actuaries
How do jewelers use math in their careers?
They use math in weight conversions and measurements.
What careers use slope intercept?
No jobs it's stupid
What are 3 careers that use proportional reasoning?
Chefs, archaeologists, and veterinarians.
Do all careers use mathematics?
Not all... some don't need mathamatics..
How do you measure EMF?
Use a voltmeter.
What do we use to test Voltage?
A voltmeter
What is the use of digital voltmeter?
the voltmeter use a SLR camera because this is the latest camera and the good light and good shot of a picture
How is voltage measured?
Use a voltmeter with a high input impedance and measure at the source the voltage.
What do you use to measure voltage in an electronic circuit?
A Voltmeter.
To measure EMF you would use a(n)?
"voltmeter"
What can you use to identify large electrical currents?
A voltmeter
What can you use to check the voltage of a battery?
Voltmeter or multimeter.
What is a use of a voltmeter?
A voltmeter is used to measure the difference in electric potential ("voltage") between two points, usually but not necessarily in an electrical circuit..
How do you convert voltmeter to ohmmeter?
First you will need a constant current source. Do NOT connect the voltmeter to the constant current source without the resistor to be measured already connected. Do NOT use a battery, it is a voltage source. Then follow these steps to measure a resistor:connect the voltmeter across the resistor to be measuredconnect the voltmeter-resistor combination across the constant current sourceread the voltmeter and record the voltagedisconnect the voltmeter-resistor combination from the constant current sourcedisconnect the voltmeter from the resistorcalculate the resistance from the measured voltage and current from the source with Ohm's law in this form: R = V ÷ IIts much easier to just use the ohms setting on a multimeter.
What are two familiar mistakes when using an ohmmeter and a voltmeter?
Voltmeter connect in parallel with the circuit setting on voltmeter highest range first then to lower range. Ohmmeter we need to use the ohmmeter meter setting connect across the resistor
Voltmeter is used for?
A volt meter is use to measure the voltage of the circuit.
