This would be concidered the largest diameter,dimension of a bolt.
If you mean two gross as a number - it is 288.
There are several meanings of gross. A gross is a dozen dozen ie 12 * 12 = 144 Gross can mean before adjustment for taxes and allowances. Gross can also mean too much or repulsive.
A gross is a dozen dozens (12X12) why it is called a gross i couldn't find out.
a 'gross' means twelve dozen or 144
2 inch long nipples is awesome. 2 inch diameter areola is gross.
That refers to the size wrench necessary to tighten or loosen the bolt.
Bolt of uniform Strength means that the entire length of the bolt is subjected to same intensity of stress,that is stress in the shank portion and the threaded portion are same.this is achieved by reducing the diameter of the shank to core diameter of the thread.
Bolt of uniform Strength means that the entire length of the bolt is subjected to same intensity of stress,that is stress in the shank portion and the threaded portion are same.this is achieved by reducing the diameter of the shank to core diameter of the thread.
he diameter of the bolt.
The stress on a bolt under longitudinal force is the total force on the bolt divided by the stress area. The stress area is a little bigger than the minor diameter area, calculated from the average of the minor diameter and pitch diameter. The total force on the bolt is its torque preload plus the (bolt stiffness/(bolt +member stiffness) x (externally applied load )
Bolt grossed $313,953,759 worldwide.
Bolt grossed $114,053,759 in the domestic market.
On a five bolt pattern measure from outer edge of one bolt then across to the middle of another skipping one bolt hole( not quite the diameter). On six or four bolt patterns measure across from bolt center to bolt center as you would the diameter if it were a circle.
"The bolt pattern or bolt circle is the diameter of an imaginary circle formed by the centers of the wheel lugs. Bolt patterns can be 4, 5, 6, or 8 lug holes. A bolt circle of 4x100 would indicate a 4 lug pattern on a circle with a diameter of 100mm." 5 x 4.50 converts to 5 x 114.3 (mm). http://www.tirerack.com/wheels/tech/techpage.jsp?techid=92
If a bolt is tightened past a certain point, it deforms by stretching, with the result that its diameter is reduced, if it is tightened past the elastic strain limit of the metal the reduction in diameter is permanent. This can often be seen afterwards in a reduced-diameter 'neck' in the shaft of the bolt where the highest stress occurred.
by using a caliperhttp://www.technologystudent.com/equip1/vernier3.htm
PCD (Pitch Circle Diameter) is the diameter of a circle that goes through each of the bolt holes. You can find it by measuring distance from centre of one bolt hole to the centre of opposite end bolt hole...