0
What else can I help you with?
How much is 2.25 inches on a ruler?
It is 2.25 inches - whether on a ruler or on a measuring tape or whatever.
What would 4.2 inches look like on a ruler?
4.2 inches is about 10.5 cm
Where is two thirds on a ruler?
On a 12 inch ruler, the 1/3 point would be 12/3, or at 4 inches.
What is 1.35 inches on a ruler?
Whether on a ruler or anywhere else, it is still 1.35 inches. No ruler is graduated with at that level of detail. A tenth of an inch is typical. So you want a point halfway between 1.3 inches and 1.4 inches. Alternatively, you can draw a line of 1.35*2 = 2.7 inches (the ruler will measure that) and then bisect it.
What does 13.16 of an inch look like on a ruler?
12/16 is 3/4 13/16 will be a hair to the right of 3/4
What does 0.11 inches look like on a ruler?
It is about just over 4 inches
How many centemeter in an inch?
4 inches are 10.16 centimeters.
What does 125 look like on a ruler?
one and 1/4
What is 10 cm on a ruler?
Approximately '4 inches'.
What does .375 inch look like on a ruler?
On a ruler, .375 inches is equivalent to 3/8 of an inch. It is located between the 1/4 inch mark (0.25 inches) and the 1/2 inch mark (0.5 inches). Specifically, it is three tick marks past the 1/4 inch mark. If using a standard ruler, you'll find it slightly closer to the 1/2 inch mark than to the 1/4 inch mark.
How much is 2.25 inches on a ruler?
It is 2.25 inches - whether on a ruler or on a measuring tape or whatever.
Where are 4.78 inches on a ruler?
You will not find 4.78 inches on a ruler. The graduations for inches are numbered and these are usually subdivided into 10. So 4.78 inches will be a tine fraction short of the eighth division after the 4 inch mark.
Where is 3.543 inches on a ruler?
Between 3 and 4 on the inches side. Inches may be divided into 10ths or 16ths but you will certainly not have a ruler that gives thousandths of an inch.
How many centimeters go into 4 inches?
bY looking at a ruler, you can tell that therre are about 9.9 cm in 4 inches
Where do you find 4.92 inches on ruler?
To find 4.92 inches on a ruler, first locate the 4-inch mark, which is usually a bit before the 5-inch mark. Then, look for the small increments between 4 and 5 inches. Each inch is typically divided into 16 smaller marks, so you would count 12 marks after the 4-inch mark to reach 4.92 inches. This represents 12/16 of an inch, or 0.75 inches, added to the 4 inches.
On a ruler How long is 100 milimeters?
100 millimeters is equivalent to 10 centimeters or approximately 3.94 inches on a standard ruler.
What would 4.2 inches look like on a ruler?
4.2 inches is about 10.5 cm
