You add a porpotion.
2 to 3
it is when a number is divided to make a whole:P
porpotion
1.25 feet.
a porpotion is an equation stating thattwo ratios are equilvalent? true or false
what you need to do is set up a porpotion. 80 over 100 is X over 3900. Then, cross multiply to get 100X = 312000. Finally divide both sides by 100 to get X by its self on one side, so X = 3120. 80% of 3900 is 3120. Hope this helps.
In a solution with a pH of 4, the concentration of hydrogen ions (H+) is higher than the concentration of hydroxide ions (OH-). The pH scale is logarithmic, so a pH of 4 indicates that the concentration of hydrogen ions is 10^-4 moles per liter, while the concentration of hydroxide ions can be calculated using the water dissociation constant (Kw).
The car which is driving straight into the parking lot has the right of entery into the parking space. When you are backing out your vehicle than you need to make sure that there is no vehicle which is comming in and whether it is safe. If you have already backed out more than 50%, than the car comming in should wait till you clear out . As per the state prevalant laws it would differ from state to state. However, each one will have to claim for the damage of the vehicle under your own policy and if there is any bodily injury than you can sue the opposite driver. However, the award for property damage and injury would be paid in porpotion to the fault fixed.
There has always been difficulties in identifying the fixes cost and variable cost for the business for almost all type of business. The cost like electricity cost,telephone cost, and fuel cost etc are the examples of the cost those add complexity in determining the fixed and variable cost. the Actual problem is that these cost occur both and at the production place and the managerial cost. For example the electricity cost increases as porpotion with the amount of the goods produced in the production plant where as it remain almost fixed in the offices.It is difficult to calculate which cost was occured at the office and on the production plant. The answe may not be satisfactory poeople can edit it.
The first step involves removing compleletely the door panel. Running the lower half and bottom are screws covered by approximelty one inch plates that pop off. Also screws in the arm reset and plate of the door handle must be removed. After removing all the screws holding the panel and poping the panel loose, it is puched upward and toward the rear of the vehicle. The entire window regulator is replaced as a unit. as simple as this piece looks it will cost over $100.00 dolars. The existing regulator is held in place by three hexhead bolts/screws attacged to the door and two hexhead attached to the lower porpotion of the window. After removing the screws, work the regulator out through the upper rear hole just below the door lock. The new regulator is replaced through the same hole. Be aware that it takes some time and patience to get the regulatlors in and out of the opening. IPY in Fresno