0
Add your answer:
Earn +20 pts
What is the hole size required for a 2.5 conduit?
A trade size hole for a 2-1/2" EMT conduit connector, the hole needs to be 2-7/8" in diameter. A 3" rigid conduit can also use this size hole without the lock nuts falling into the hole.
What size conduit for 400 amp service?
4 inch rigid conduit
How do you put a 2 inch piece of condiut inside a half inch piece of conduit without altering the size of the conduit in any way?
It is easy to put a 2-inch long piece of conduit that is less than half an inch in any cross-sectional measure into a half-inch conduit.
What size should under ground conduit be from pole to meter base?
For new 200 amp services the conduit size should be 3 inch PVC.
The largest conduit trade size in which a short nipple of 2.5 inch length is available is?
3inches
What is the diameter size of EMT conduit?
EMT is electrical metallic tubing. In the electrical trade there are nominal sizes expressed as a standard size. To answer your question you must state the conduit size in either electrical terms or in standard size terms to get a conversion size.For example standard size 1/2" EMT has an actual diameter size of 3/4" and the 1/2"EMT connector for the 1/2" EMT conduit needs a 7/8" hole.Likewise with 3/4" EMT the actual outside diameter is 15/16" and the 3/4" EMT connector needs a 1-1/8" hole.
What size subwoffer will fit in a 9 inch hole?
8 inch sub
Is it legal to support a conduit from another conduit of the same size?
No, the conduit has to be supported individually from a supportive structure. The spacing of the strapping is related to the size of the conduit.
What is the smallest size emt conduit that can be used with nineteen 10 gauge thwn wires?
1 1/2 inch
What size conduit is needed for a 100 amp service according to the nec?
According to the NEC, a minimum of 1.5-inch conduit is required for a 100 amp service. It is important to follow local codes and regulations which may vary. Consulting with a licensed electrician is recommended for proper installation.
What size rigid conduit for 400 amp service?
For a 400 amp service, you would typically use a minimum of 3-inch rigid metal conduit (RMC) to accommodate the large conductors required for that amperage. It's essential to consult local electrical codes and regulations to ensure compliance with sizing requirements for your specific installation.
How many 10 stranded conductors can you pull in a 1 inch conduit?
Need to know the wire # size to compute wire fill in conduits
