The metal block's density is about 13.636 g/cm3
2
They you are the proud owner of a block of metal with a volume of 56 cubic centimetres and a mass of 153 grams. Enjoy!
Density = Mass/Volume = 25g/5mL = 5 g per mL
If the water is at standard temperature and pressure (25 degrees Celsius and one atmosphere), the water has density of 1 kilogram per liter. When submerged, the metal displaces its own volume of water. Therefore, the volume of the metal is 1 liter, and the density of the metal is 6 kg/liter.
Density = Mass/Volume = 16/2.8 g/mL = 5.714 grams per mL (approx).
Density is mass divided by volume. D = (750g/55cm3) D = 13.63636 g/cm3
Density = Mass/Volume = 13.6 g/cm3
Just divide the mass by the volume.
-4.22
what is the unit for the mass density = mass over volume volume= length*height*width check the units whether you need to convert or no and then complete it
Density is the mass of the object divided by its volume. By this principle, to determine the density of a metal, place the metal onto a scale to measure its mass. After this, place the metal into a beaker of water and measure the volume change in the beaker. Divide the mass by the volume and you get the density.
Density = g / Cm Assuming g is in a unit of mass, and Cm is in a unit of volume, If these are not the units of the quantities given then the result will not be density, instead it will be gibberish! The units of the quantities going into an equation are more important than the values.
The density of the metal will remain the same. However because the volume of the object has been reduced the overall density will increase
The density is the ratio of mass to volume. It doesn't matter what size the piece of metal, if it is the same metal it has the same density, 8.4.
Air bubbles would make the volume you read in the measuring cylinder increase from the actual volume of theliquid. so when you add in the metal, there would be an increase in the volume of the metal than it really is. the mass of the metal cannot be affected by air bubble because this is the amount of matter in the metal. This increase in volume causes the density of the metal to reduce from its original value. since mass is constant, density is inversely proportional to volume. As volume increases, density decreases.hope that was helpful.
density = mass/volume,so the density of your metal is:25/10 = 2.5g/cm3 (grams per cm cubed)
The measurement unit for volume is not a centimetre and so the volume cannot be W cm and, in that respect, the question is flawed. If you meant W cubic centimetres, then the density is 525/W grams per cubic centimetre.