A rough Surface
A.Lines that are equally steep should have the same slope.B.The slope of a steep line should be bigger than the slope of a flat line.D.Lines that go up from left to right should have a positive slope.E.Lines that go down from left to right should have a negative slope.-----------------------------------------------------------------------------------------------------B.The slope of a flat line should be close to 0.C.The slope of a flat line is smaller than the slope of a steep line.E.A negative slope means that the line moves down from left to right
Slope is rise over run, so if you have a rise of 2 and a run of 4, then the slope is 0.5. If the table gives rises and runs, then just follow the two until they meet, that should be the slope.
A cone with the radius of 5 cm and slope height of 9 cm has a total surface area of approximately 219.91cm2
For proper fall. Pipe should slope 1" for every 8'.
The slope will be negative.The slope will be negative.The slope will be negative.The slope will be negative.
Answer is A riged surface prevnts slipping on a slope.
A bumpy, rough surface so you don't slip.
A bumpy, rough surface so you don't slip.
To prevent slipping, a sloped surface should have a roughened surface, one that provides ample friction. Smooth surfaces such as polished stone, metal, or wood are not as safe as gritty concrete, rough brick, or asphalt. In some cases, strips of sandpaper-like material are added to slopes or steps to make them safer to walk on.
smooth surface
Parallel to the surface of the slope and opposite to the movement of an object on the slope. Parallel to the surface of the slope and up-slope, in the case of an object resting in place on the slope.
ice or rocks
noo its alittle dangerous chances of slipping
The appropriate release slope can avoid the product pulling hair (pulling flowers). Smooth surface of the mold slope should be ≥ 0.5 degrees, fine grain (sand surface) surface is greater than 1 degree, coarse grain surface is greater than 1.5 degrees.
an angled surface
slope
No slope is the angle at which a surface goes up or down.