0
Add your answer:
Earn +20 pts
What is the answer if a number is multiplied by zero?
Any number multiplied by zero is equal to zero. Think of it this way - if you have 13 lots of zero, you still have zero. However many lots of zero you have, you have zero.
How do you write 0.004 in words?
Four thousandths.
Is zero positive?
No. Zero is neither positive nor negative. You might think of it as being neutral.
Is -5.4 greater than -5.9?
0.5
What does zero minus negative three equal?
"minus zero" is the same as plus zero in that it makes no difference to the sum. So the answer is -3.
Who attacked zigzag when he was beating up stanly?
Zero attacks ZigZag when he is beating up Stanley.
In the book Holes by Louis Sachar what were their nicknames?
X-Ray, Zigzag, Zero, Caveman, Squid, Armpit, Lump and Twitch, I think. Sorry if i missed any out!
Letter z words?
zebra zero zoo zinnia zipper zigzag
Who does Zero strangle in the book Holes?
Zero strangles Zigzag because he was attacking Stanley. If this helps as well, this action shows how protective Zero is to Stanley.
Why did zigzag attack Stanley?
Zigzag attacked Stanley because Stanley was putting dirt in Zigzag's side of the hole and Zigzag was getting mad and that caused Zigzag to hit Stanley with the shovel.
Who is the people in group D with Stanley?
Zero, Zigzag, Armpit,X-ray, Magnet and Squid
French words that begin with z?
Here are some French words that begin with "z": zoo (zoo), zéro (zero), zigzag, zeste (zest), zébrure (stripe).
How many time a hbsinfected person can sleep with girl daily?
dude no, zero times. zero.
What are the secondary characters of the book Holes by Louis Sachar?
Mr.Pendanski,The Warden,X-Ray,Armpit,Squid,Magnet,Zigzag and Zero
How does Zigzag from Holes act?
He's very annoyed because Zero is digging a part of Stanley's hole and nobody is helping him dig his hole.
Wizard citation 3KC8838 works except you are not able to stop the zig-sag would like to do a straight stitch you believe you have the needle and dial is set in proper position?
# Set pattern indicator to M (zigzag)# Set stitch length to 1 - 4 # Set zigzag width to '0' (zero) # Use straight or zigzag foot # Use straight or zigzag needle plate # Set needle position to 'M'(middle) # Feed dogs UP Good luck!
How many people did lilwayne kill?
zero. this is a weird question: he's a rapper, not a murderer
