There's no rule that says you have to do that, and you certainly aren't required
to do it if it makes you uncomfortable. You can perform the multiplication using
any other legitimate procedure. After a while, though, you'll begin to notice that
when you multiply any whole number by 10, the answer is always the same number
with a zero on the end of it. Eventually, you'll regret all the time you spent doing it
the hard way, and you'll adopt the easy way, out of convenience..
Simply add one ZERO to the end of the number. If the number is a decimal, then move the decimal point one postion to the right.
just add a zero
If you add zero to any number, the sum is the same number you started with.
When you add a number to itself, you are multiplying it by 2. The usual term for this is you are doubling the number.
If the base numbers or variables are the same, you add the exponents.
That's a phenomenon that you notice after the fact. Try it out. Multiply any whole number by ten. 3 x 10 = 30 492 x 10 = 4920 It's the way the decimal system is structured. Ten to the first power is ten. Ten to the second power is one hundred. Since multiplying a number by ten adds a zero, the reverse is true. Adding a zero to the back of a number multiplies it by ten.
Just add a zero after the number. 123 x 10 = 1230
2,700When multiplying by 100 just take the zero's off of the 100 and add them to the number you are multiplying. 27 becomes 2700 in this example.
Simply add one ZERO to the end of the number. If the number is a decimal, then move the decimal point one postion to the right.
You can add a period, and a zero, after the whole number. Or you can just consider the whole numbers themselves a special kind of "decimal number".
just add a zero
You multiply the denominator by the whole number, then you add what you got from multiplying the denominator by the whole number by the numerator! An example:13/4 would equal 7/4 as a improper fraction!
Apart from using a calculator, specifically if you multiply a whole number by a power of 10:* To multiply a whole number by 10, add a zero to the whole number. * To multiply a whole number by 100, add two zeros to the whole number. * Etc.
If 2340 is a whole number then just add a decimal point and a zero -- 2340.0
You add exponents when multiplying. Ex: (xm) × (xn) = xm+n
To multiply a whole number by 10, just add a zero...
If you are multiplying powers of the same base (like 24 times 211), yes, you add the exponents.