None, since there can be no conversion.
A ton is a measure of mass. A cubic yard is a measure of volume. The two measure different things and, according to basic principles of dimensional analysis, conversion from one to the other is not valid.
The answer depends upon the material to which you are referring too. A cubic yard of compressed cotton is obviously going to weigh less than a cubic yard of steel.
2.2 Tons
No where near 1 ton.
One cubic yard of concrete typically weighs about 4,000 pounds, which is equivalent to 2 tons. This weight can vary slightly based on the specific mix and aggregate used, but 2 tons is a standard estimate for most concrete.
Insufficient data to answer, a cubic yard is a measure of volume (3feet x 3feet x 3feet); whereas a ton is a measure of mass/weight (2000 pounds). Different materials have different weights. A "yard" of feathers will weigh a lot less than a "yard" of mud. A cubic yard in shiping is counted as a ton.
One cubic yard of broken limestone weighs about 1.3 tons. One cubic yard of pulverized limestone weighs about 1.17 tons.
Multiply tons by 1,529.11 to get pounds per cubic yard:* 3.3 x 1,529.11 = 5,046.063 pounds per cubic yard
as a rule of thumb, 1 cubic yard of concrete weighs about 4,000lbs or 2 short tons
1 cubic yard = 1.3 tons
8
There is approximately 1. 35 tons in a cubic yard of fine sand.
A cubic yard of 57 gravel typically weighs around 1.4 tons or 2,800 pounds.
To convert cubic yards of dirt to tons, you need to know the density of the dirt, which typically ranges from 1.5 to 2 tons per cubic yard. Assuming an average density of 1.5 tons per cubic yard, 27,000 cubic yards of dirt would weigh approximately 40,500 tons. If using a density of 2 tons per cubic yard, it would weigh around 54,000 tons. The exact weight will depend on the specific type of dirt.
1.6 tons
The answer depends upon the material to which you are referring too. A cubic yard of compressed cotton is obviously going to weigh less than a cubic yard of steel.
the answer is about 1.18 short tons. the answer is about 1.18 short tons.
This is not a valid conversion. Cubic units is a measure of volume while square units is a measure of area. Generally, volume is determined by multiplying length x width x depth. Area is normally determined by multiplying length x width.