0
REPEAT 2 [RT 45 FD 100 RT 135 FD 100]
Still curious? Ask our experts.
Chat with our AI personalities
Fran
Devin
BlakeTo draw a rhombus using the Logo programming language, you can use the following commands:
- Use the "forward" command to move the turtle forward.
- Use the "right" or "left" command to change the direction of the turtle.
- Repeat the forward and turn commands to create the four sides of the rhombus, ensuring that the opposite sides are of equal length and the angles between adjacent sides are 90 degrees.
- Finally, use the "penup" and "pendown" commands to lift and lower the pen as needed to avoid drawing unnecessary lines.
Well, isn't that a happy little question! To draw a rhombus using the Logo command, you can use the "repeat" command to create a series of steps that form the shape. Start by moving forward a certain distance, turning a specific angle, moving forward again, and so on, until you have all four sides of the rhombus. Just remember, there are no mistakes, only happy little accidents in art!
Well, honey, to draw a rhombus using the Logo command, you start by moving forward a certain distance, then turn a certain number of degrees, move forward again, turn some more, rinse and repeat until you've got yourself a fancy rhombus. Just make sure your angles add up to 360 degrees, or else you'll end up with a wonky shape that even Picasso would side-eye.
Add your answer:
Earn +20 pts
What is the logo command for rhombus?
In Logo programming, the command to draw a rhombus can be achieved using the combination of FORWARD and RIGHT (or LEFT) commands to create the desired angles. A typical command sequence might look like this: REPEAT 2 [FORWARD 100 RIGHT 60 FORWARD 100 RIGHT 120], where you adjust the angles and lengths as needed to create a rhombus shape.
What store has a logo that looks like a rhombus?
Renuealt
What store has a logo that looks like a silver rhombus?
Renuealt
How do you draw triangle using blackcat logo?
fd 50 rt120 fd50 rt120 fd50 rt 120
What commands to draw heptagon in logo?
To draw a heptagon in Logo, you can use the following commands: REPEAT 7 [FORWARD 100 RIGHT 51.43] This command moves the turtle forward by 100 units and turns it right by approximately 51.43 degrees, repeating this process seven times to form a heptagon. Adjust the FORWARD value to change the size of the heptagon.
