Those two are not comparable - 200 MB is a unit of data storage, while 1.0 mbps is a unit of bandwidth (commonly called "speed"). This is like comparing a distance (in kilometers) with a speed (in kilometers/hour).
It's obviously 10 Mbps
..What is the difference between 10 mbps and 54.0 mbps?.
Cable modems runs faster than DSL. Cable internet supports approximately 30 Mbps of bandwidth, whereas most forms of DSL cannot reach 10 Mbps.
Even a slow Ethernet network would be faster than ADSL, since 10baseT LAN networks run at 10 Mbps. An ADSL connection typically tops out at around 8 Mbps. However, if you are talking about throughput, then they might be very close, since Ethernet has problems with packet collision. Then again, most Ethernet networks today for LANs run at 100 Mbps, which would place it far faster than ADSL based on speed measurements. However, ADSL does not use the same transmission method as Ethernet, but Ethernet will still be faster than ADSL (especially if you consider the Gigabit speeds).
In most cases, yes, cable internet service is faster than DSL. DSL does have known bandwidth limitations that are lower than cable connections, theoretically. Most companies offering DSL utilize ADSL or SDSL technology which has limitation of download transmission of 10 MBPS whereas cable can deliver top speeds of 30 MBPS, depending on traffic and the service subscribed to.
10 to 1000 Mbps for less than +/- 100m
There are several different internet speeds available when it coems to high speed. First there is dsl obviously the slowest then next there is broadband with ether 1 mbps, 3 mbps, 5mbps, 10 mbps, and 20mbps. Any faster than 20 is extremely uncommon and would more than likely not serve you any real purpose for the cost.
Ethernet LANs have transmission rates of 10 Mbps, 100 Mbps, 1 Gbps and 10 Gbps For an X Mbps Ethernet (where X = 10, 100, 1,000 or 10,000), a user can continuously transmit at the rate X Mbps if that user is the only person sending data. If there are more than one active user, then each user cannot continuously transmit at X Mbps.
Full duplex means it can receive and send at the same time.10 100 means it supports both of these speeds (10 Mbps and 100 Mbps).Full duplex means it can receive and send at the same time.10 100 means it supports both of these speeds (10 Mbps and 100 Mbps).Full duplex means it can receive and send at the same time.10 100 means it supports both of these speeds (10 Mbps and 100 Mbps).Full duplex means it can receive and send at the same time.10 100 means it supports both of these speeds (10 Mbps and 100 Mbps).
advantage: it is really cheap. disadvantage: the top speed is only 10 Mbps
10 - 7 = 3 3 mbps faster.
A T3 line runs at speeds of 44.736 Mbps. Faster alternatives include ethernet connections like 10 Gbps fiber optic or higher-speed leased lines such as OC-3, OC-12, or OC-48 lines, which offer significantly faster data transfer rates.