Wiki User
∙ 11y ago80 gpm
Wiki User
∙ 11y agoYes, easily.
10gpm
A copper pipe would be better as a conductor due to copper's high electrical conductivity. It would allow electric current to flow efficiently through the pipe, making it a good choice for applications where electrical conductivity is important.
If the old steel pipe was half inch, it is recommended to replace it with half inch copper pipe to maintain consistent water flow. Using a larger diameter pipe (3/4 inch) may lead to reduced water pressure and inefficient operation. Stick to the half inch size for best results.
A pipe that is 10 inch would have the velocity of 2.75 feet. This is 2.75 feet with 722 GPM.
That depends entirely on the viscosity of the liquid in the pipe ! Water would flow faster than oil !
It would 2.75 feet with a 10 inch pipe. It would be 2.75 feet with a volatility of 722 GPM.
If the flow velocity remains the same the flow volume will increase by the square of the diameter ratio.(2/1.25) = 1.6 = diameter ratio1.62 = 2.56 more flow volume through 2 inch pipe compared to 1.25 inch pipe.
Water flow rate half inch PVC pipe 65 psi?
The time it takes to flow 300 gallons through a 1 inch pipe at 55 psi depends on the flow rate of the pipe. You would need to know the flow rate in gallons per minute (GPM) of the 1 inch pipe to calculate the time it takes. Without the flow rate, it is not possible to determine the exact time it will take.
YES there is
I have recently had to join a 1 inch steel water pipe to a new copper 28mm pipe. You can do this using a 28mm comression joint. 1inch is just uneder 28mm in diameter but the compression joint takes up the difference and works without fault or leaks.