answersLogoWhite

0


Best Answer

To my knowledge there is no such a thing as a 1000 volt cooking microwave oven. If you mean 1000 watt then the answer to your question is yes. W = A x V. Presuming that the 15 amp receptacle is on a 120 volt system then the amperage draw on a 1000 watt microwave oven would be A = W/V 1000/120 = 8.3 amps with 6.6 amps to spare.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Can a 1000volts microwave be connected to a 15amp receptacle?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Electrical Engineering

Can you use a 15amp outlet on a 20amp circuit?

No. You aren't allowed to install a device rated greater than the circuit is rated.The 20 amp receptacle would allow you to plug in 20 amp loads (which is why it is different than a 15 amp receptacle), and plugging a 20 amp load into a 15 amp circuit would cause an overload and the 15 amp circuit breaker would trip.ADDITIONThis may still be open for discussion. According an electrician from RKO Electric, you can in fact install a 20 Amp GFCI receptacle on a 15 Amp breaker. Apparently, the breaker will trip well before the receptacle is able to pull 20 Amps of current into the line. Please see the following link from another website: http://en.allexperts.com/q/Electrical-Wiring-Home-1734/20-amp-GFCI-outlets.htm2003 NEC Code Book says:210-21(b)(1), p.70-42: A single receptacle on an individual branch circuit shall have an ampere rating of not less than that of the branch circuit. To me this indicates that if there's only one receptacle on the circuit, you can't have an outlet rated for less than the circuit, but it neither mentions nor prohibits oversizing the receptacle.210-21(3), p.70-42: Where connected to a branch circuit supplying two or more receptacles or outlets, receptacle ratings shall conform to the values listed in table 210-21(b)(3)... which says: 15amp circuit, not over15amp receptacle (


Is a double throw 15amp breaker the same as a 30 amp breaker amp?

You have a double pole breaker for 240Volt supply. The maximum current is 15 amp.


How many 50 watt lights on a 15 amp circuit?

50 watt equals less than 1/2 amp current flow at 120 volts so you can have 30 light on a 15amp breaker or 40 on a twenty amp breaker.


Can you use32amp circuit for a 15amp appliance?

If it is a 32-amp circuit you can use any appliance that takes less than 32 amps. That includes a 15-amp appliance. All appliances fed from that circuit must use 32 amps or less in total.


How many watts and romex gauge is safe for a 15amp breaker?

Assuming 120 VAC in a residence maximum watts = 15 x 120 = 1800 Watts. For a continuous load you can support 1440 watts which is 80& of maximum. You need 14 AWG gauge wire.

Related questions

How can you find the ampage on an empty home fuse receptacle without calling an electrician?

A breaker box circuit fuse? Check the wire size. 14gauge use 15amp. 12 gauge use 20 amp.


How much wattvoltage rough estimate would a house need for - 10 50W lights 1 TV 1 refrigerator 1 wall unit air conditioner 1 microwave 1 washing machine?

you will need 1-15 amp circuit 120 volts with 14 guage romex wire for lights / you will need 1- 20 amp circuit with 12/2 romex going to receptacle that microwave will plug into in Virginia this has to be a dedicated circuit meaning nothing else but microwave can be plugged into this receptacle. the same rules apply also to the washer and the refrigerator as the microwave. the t.v. also should have 1-20amp receptacle to plug in to but this doesn't have to be a dedicated circuit and other items can be plugged into this receptacle such as vcr's lamps etc. you did not say whether you were planning on having a 120 volt air conditioner or a 230 volt a/c but either way you will need a dedicated circuit with either 1-20amp receptacle using 12/3 romex wire or 1-30amp receptacle using 10/2 romex wire. be sure to match your breaker size to your wire size 14/2 wire size = 15amp breaker 12/2 wire size = 20amp breaker and 10/2 wire size = 30amp breaker. so if this is a new install you will need a total of 6 new breakers i can not give you the wattage or power consumption for anything but the lights which will pull about 500 watts if all on at the same time pulling about 4.3amps


What happens if you use a 20amp fuse when the microwave oven calls for a 15amp fuse?

The fuse is there to protect the wiring in your home not the microwave. Using a larger fuse than required for the wiring causes a fire hazard. You can end up burning your home down. Use only the fuse recommended.


What would happen if you ran a rang off a 15amp breaker?

is it polesible to run a range of appliances on a single 15amp receptical


Which fuse is the one you change for the stereo on a 1990 VW Cabrio?

In the fuse box, it is #3 15amp which is blue. Also connected to the back side of the radio itself there may be a red 10 amp one.


Can you switch from 15amp to 20amp on a double pole breaker?

The minimum size wire a 20 amp breaker needs to be connected to is a #12 wire. The 15 is probably connected to a #14 right now which is only rated for 15 amps. Remember the breaker is sized to the wires ampacity not the load .


What fuses go where in a 1986 Toyota pickup?

15amp


What size fuse in a Honda cb350?

6x32mm 15amp


Which fuse controls the srs light in a 1998 Honda Civic?

13(15amp) second row second one 13(15amp) second row second one


What is the fuse number for the horn on a 1989 Toyota Corolla?

15amp


What is the fuse layout for a 1994 Ford Ranger XLT?

fuse position rating circuit protected 1 10amp power mirror 2 10amp airbag system/blower relay 3 15amp parking lamps 4 15amp left headlamp 5 10amp on board diagnostic II sys 6 not used 7 10amp illumination sys 8 15amp right headlamp/fog lamp sys 9 10amp ABS sys 10 10amp speed control/GEM sys/brake interlock 11 10amp warning lamps 12 10amp front washer sys 13 15amp PCM/stop lamps/4wd/ABS/speed cont 14 10/20amp ABS sys 15 15amp airbag sys/alternator 16 30amp front wiper 17 30amp cigar lighter 18 15amp A/C sys 19 25amp ignition coil/PCM sys 20 10amp radio/GEMsys/anti-theft 21 15amp hazard lamps 22 15amp turn signals 23 not used 24 15amp starter relay/anti-theft 25 10amp speedometer/GEM sys 26 15amp A4LDE trans/bck up lamps/DRL sys 27 15amp underhood LP/maplights/glove box lamp dome lamp/visor lamps/4x4 sys 28 10amp GEM sys 29 15amp audio sys 30 not used 31 not used 32 not used 33 20amp high beam lamps 34 not used


I need to know what the fuse panel diagram for a 1994 ford ranger xlt is?

fuse position rating circuit protected 1 10amp power mirror 2 10amp airbag system/blower relay 3 15amp parking lamps 4 15amp left headlamp 5 10amp on board diagnostic II sys 6 not used 7 10amp illumination sys 8 15amp right headlamp/fog lamp sys 9 10amp ABS sys 10 10amp speed control/GEM sys/brake interlock 11 10amp warning lamps 12 10amp front washer sys 13 15amp PCM/stop lamps/4wd/ABS/speed cont 14 10/20amp ABS sys 15 15amp airbag sys/alternator 16 30amp front wiper 17 30amp cigar lighter 18 15amp A/C sys 19 25amp ignition coil/PCM sys 20 10amp radio/GEMsys/anti-theft 21 15amp hazard lamps 22 15amp turn signals 23 not used 24 15amp starter relay/anti-theft 25 10amp speedometer/GEM sys 26 15amp A4LDE trans/bck up lamps/DRL sys 27 15amp underhood LP/maplights/glove box lamp dome lamp/visor lamps/4x4 sys 28 10amp GEM sys 29 15amp audio sys 30 not used 31 not used 32 not used 33 20amp high beam lamps 34 not used