Yes. They're essentially the same as 110-115-120 are the same. The power that comes into your house is 240V, but by the time it's transferred through wires and breakers and outlets, it drops to about 220-230V. So anything between 220-230-and-240 is the same thing.
230 volts and 240 are close enough to be considered the same. a generator that is 15 amps will draw up to 15 amps of the amps that your generator has to offer. So the answer is yes.
Yes, you can always have heavier wire than code requires.
It could if you don't get the terminals and motor wires on the correct terminals.
If you are no longer using the dryer and there are 4-wires, and the dryer was 220 to 240 volts, it can be split into two 110 to 120 Volt circuits.
In the US the voltage is about 220 volts. This voltage is based upon the average voltage of the AC sine wave. It can peak as high as 240 volts or as low as 210 volts. So these different voltages are actually referring to an average 220 volt system.
It is not just the outlet, but the wiring and breakers that need to be compatible with your 240 Volt appliance. Get an electrician to look at your requirement.
Yes you can, it was manufactured before the new European standards were brought out. I have no trouble with my 220 volt appliances.
If the appliance is 220 volt 60 Htz, yes it will work perfectly in the U.S. plugged into a 240 volt outlet.
Yes, it can. But e.g. a light bulb will have a shorter living time.
Yes 220 & 240 are considered the same.
France uses 220-240 volts for their electrical system.
Yes. As far as in the US 220v and 240v is pretty much the same thing. People call it 220 but realistically you prob have 230-240v. Get a cheap voltage tester and check it out
No, but if you ever switch to an electric stove you will have problems getting a 240 volt circuit to that location. I would go ahead and install a 240 volt outlet at that location if this is new construction. Costs very little and you will be all set for the future.
Yes, you can always have heavier wire than code requires.
It could if you don't get the terminals and motor wires on the correct terminals.
Can you supply three 220 -240 volt 16.6 amp infrared heaters with one circuit?
On a 240 volt outlet, such as a dryer outlet: G is Ground, W is Neutral, X and Y are the two Hot legs.
If you are no longer using the dryer and there are 4-wires, and the dryer was 220 to 240 volts, it can be split into two 110 to 120 Volt circuits.