Green and bare are both grounds and can be connected. To double check you could use an Ohm meter and make sure the green wire is connected to the cook-top chassis.
The new cooktop has a 4 wire connection. Red & Black are hot. White is neutral, and green is ground. You existing panel is wired with 3 wires. Black & Red are hot and green is ground. There is no neutral wire. Connect the black to black, red to red, and then connect the white and ground together at the plug.
There should be two outputs on the 30 A breaker. You will need 10 AWG wire with 3-conductors and ground. Typically the wire colors will be Black, Red, White and (Green or bare). Connect black to one output of breaker and red to other output. Connect white to the white buss bar in main panel and green/bare to ground buss bar. At heater end connect the red and black to the 240 V leads, white to white and green/bare to the heater case.
Do you mean a 3 wire receptacle? You say cable,are you talking like extension cord type or interior romex wiring? If romex, you should have a black, white and bare(green or ground)and possibly a red if a 4 wire . Connect black to gold on the receptacle,white to silver and ground to the green screw.
Black wire is HOT, white wire is NEUTRAL and bare or green wire is GROUND. The black wire goes to brass colored screw, the white wire goes to silver colored screw and the bare wire goes to green screw that is connected to the metal "frame" of the receptacle.
you take the blue wire and connect it with the red then connect it to the yellow then you cut the green wire and there you go!
The new cooktop has a 4 wire connection. Red & Black are hot. White is neutral, and green is ground. You existing panel is wired with 3 wires. Black & Red are hot and green is ground. There is no neutral wire. Connect the black to black, red to red, and then connect the white and ground together at the plug.
Green typically represents a ground so you would connect to the bare wire at receptacle or look for a green headed screw.
Black wire to copper screw, white wire to silver screw, bare copper ground wire to green ground screw.
There should be two outputs on the 30 A breaker. You will need 10 AWG wire with 3-conductors and ground. Typically the wire colors will be Black, Red, White and (Green or bare). Connect black to one output of breaker and red to other output. Connect white to the white buss bar in main panel and green/bare to ground buss bar. At heater end connect the red and black to the 240 V leads, white to white and green/bare to the heater case.
Do you mean a 3 wire receptacle? You say cable,are you talking like extension cord type or interior romex wiring? If romex, you should have a black, white and bare(green or ground)and possibly a red if a 4 wire . Connect black to gold on the receptacle,white to silver and ground to the green screw.
Connect the green wire to the brown striped black wire.
Grounding of I and C? to ground something is to have a wire that goes to a grounded connection the bare wire in a normal wire set.
If you mean 2 bare copper wires those are the ground wires. Tie them together and then connect the light fixture ground wire which will be green or bare copper to those ground wires.
Black wire is HOT, white wire is NEUTRAL and bare or green wire is GROUND. The black wire goes to brass colored screw, the white wire goes to silver colored screw and the bare wire goes to green screw that is connected to the metal "frame" of the receptacle.
The grounding conductor is green, green with a yellow tracer or bare copper.
the green is the signal wire and it goes to the negative side of the ignition coil
you take the blue wire and connect it with the red then connect it to the yellow then you cut the green wire and there you go!