The critical element is if they match the connectors in the electric panel and you use the correct amperage breaker for the wiring of the circuit. Connectors to the electric panel must match exactly because you don't want to force the replacement breaker or have it not fit when the panel cover is reinstalled.
----
The above stated matters to an extent but not really the issue. It is much deeper to the extent that if not UL rated for that panel or a direct replacement via corporate buy out over the years it can become A. an issue and fail inspection B. a hazard well beyond amp rating of the breaker or "fitting correctly when panel cover reinstalled" C. without being UL rated or an acceptable replacement it can become an insurance issue, that could fall on homeowner or inspector or whomever last worked inside the panel. I just grazed the surface. Some breakers are well made, some manufacturers deceive even to get UL rating when in fact they tested improperly etc...
Yes some breakers can replace challenger breakers. Often falling in line with which company bought out challenger or the rights. Read tag on load center to find out what breaker types are acceptable. Then proceed to search which manufacturers make breakers that are acceptable within that panel. wash. rinse. repeat. keep digging.
Legally, you must use the same brand breaker with the brand panel. They sell Murray breakers at your area electrical contractor shop, but used I am sure. However, square d homeline, siemens ite, GE, cutler hammer BR do fit but will void the UL listing and are dangerous to mix. Upgrade your panelboard. It is old.
sand, silt, clay, and other particles and sediments mix with water.this mix forms very dense water.
Any electrical supplier should be able to get that for you. Check you local Yellow Pages for electrical suppliers. <<>> A GDP 200 is an older type breaker that was manufactured by General Switch. It had a 10KAIC (interruption capacity). This type of distribution panel was used 40 to 50 years ago. The main breaker is almost next to non existent. The main breakers were manufactured by a different company and General Switch used them in their panels. You might look on EBay under electrical breakers. The original branch circuit breakers are also hard to find but some different brands will fit. There are some sites on the net that refurbish old breakers for your type of scenario. Safety wise it is not a good idea to mix and match breakers. You might want to consider budgeting for a distribution panel change.
Almost any other gas.
True.
Legally, you must use the same brand breaker with the brand panel. They sell Murray breakers at your area electrical contractor shop, but used I am sure. However, square d homeline, siemens ite, GE, cutler hammer BR do fit but will void the UL listing and are dangerous to mix. Upgrade your panelboard. It is old.
htydyjd
Decisions at the first level of product management involve the marketing mix for an individual brand/product. These decisions are the responsibility of a brand manager (sometimes called a product manager).
The man role of the marketing mix is to promote a brand and create awareness. The marketing mix is summarized as 4Ps which stands for price, place, promotion and product.
I say brand is a marketing objective but when brand recognition becomes strong the brand can become the product.
Meow Mix was originally a product of Purina, but as of May 2006, the brand was acquired by Del Monte Foods.
As long as it is the same grade of motor oil the brand name should not matter.
the set of all brand lines (all product_original, line and category extension) that a particular seller makes available to buyers.
Arix is the best brand
jack Russel terrier was the mean kids dog and kyle masseys dog (main character) was alabrador mastiff mix...
Betty Crocker cake mix has always been the best. It is to make but is also of high quality.
Most any brand of two cycle oil. Most come in bottles that mix with a gallon of gas.