Yes, as long as it is simply an on off switch. The switch only opens and closes a contact point.
No, the switch could arc over when turned off burning its contacts. Some switches might weld shorted, making it permanently on.
your house has 220 you must use a 2 pole breaker. your wiring will change ,not a do it your selfer call someone
No, you cannot use a 10 amp switch to open a window in a 12 volt DC system. This is because the switch would not be able to handle the current necessary to power the window motor. The amount of current required to open a window in a 12 volt DC system is typically much higher than 10 amps, and so the switch would not be able to cope with the load. In addition, the switch would not be able to sustain the current necessary to keep the window open, which could lead to the window becoming stuck in the open position. Furthermore, the switch would not be able to handle the circuit protection requirements necessary to keep the window safe. For these reasons, it is not recommended to use a 10 amp switch to open a window in a 12 volt DC system.
A breaker is based on wire size, as the breaker protects the wire and not the load. This is a voltage drop question. A #3 copper conductor will limit the voltage drop to 3% or less when supplying 60 amps for 110 feet on a 110 volt system.
USE INVERTER USE INVERTER USE INVERTER
'Lighting', or the amount of light is not measured in watts. A 'watt' is a unit of power, measurement of current drawn. Most 100 watt/110 volt lamps initially produce 1690 lumens (a 'lumen' is the measure of the total "amount" of visible light emitted by a source). A 15 foot by 10 foot room is not very big, and one or two 100 watt incandescent lamps on a ceiling light fixture on a 120 volt service can light it adequately. I mention "110 volt" as in parts of the world with 220 mains these numbers change. As the voltage is doubled, the watts required would halve for the same amount of light. In other words, all other things being equal, a 50 watt 220 volt lamp should use the same amount of power, producing the same amount of light as a 100 watt 110 volt lamp.
Only use 110-120 volt appliances on a 110 volt socket.
If you mean 110/240, yes, but there may be a hidden switch to switch it to 240 volt mode. Check the manual.
no
The RV has a 12 Volt DC power supply that operates all the 12 Volt DC items in your RV when your plugged in to 110 V AC.
No. 110 volt is AC current
No, unless it is dual rated for 110 - 220 volt use. Check the manual or look at the rating sticker that should be somewhere on the printer.
You need a step down voltage transformer that converts 220 volt to 110 volt to use a 110 volt printer with 220 volt. You can get good quality transformers at East West International in Houston, TX. If you order online or over the phone, they can ship it to you in 2-3 business days.
no
yes
No, the voltage rating of the switch is too low.
No a 230 volt appliance should not be pluuged into a 110 volt socket (And vice versa) you need to buy a converter that can be plugged into the 110 volt outlet then the appliance can be plugged into the converter.
Yes, the two voltages are in the same voltage range.