No, you cannot use a 10 amp switch to open a window in a 12 volt DC system. This is because the switch would not be able to handle the current necessary to power the window motor. The amount of current required to open a window in a 12 volt DC system is typically much higher than 10 amps, and so the switch would not be able to cope with the load. In addition, the switch would not be able to sustain the current necessary to keep the window open, which could lead to the window becoming stuck in the open position. Furthermore, the switch would not be able to handle the circuit protection requirements necessary to keep the window safe. For these reasons, it is not recommended to use a 10 amp switch to open a window in a 12 volt DC system.
To be legal the switch must have a DC rating on it. If the switch is DC rated then the 12 volt load amperage can not be higher than the switch's DC rating.
Yes, as long as it is simply an on off switch. The switch only opens and closes a contact point.
5 megohms
France uses 220-240 volts for their electrical system.
Home Depot
12 volt
Yes, just make sure it is a 220 volt switch.
No. Not safe to do so. The distances between contacts may not be sufficient.
Remove the window switch panel, Spray switch contacts with WD40. Test operation. Not working? Check voltage on switch contacts. 12 volts on input and at least 11 volt on output to window motor when activated is required.
If you mean 110/240, yes, but there may be a hidden switch to switch it to 240 volt mode. Check the manual.
no
1954-1955
1956
No, the voltage rating of the switch is too low.
No
The 1952 Dodge truck line used a 6 volt electical system with a generator.
No. Is a 6 volt system.
Get someone who is qualified before you set your house on fire