Probably not, since a volume control switch is designed for extremely low current measured in fractions of a watt, while a dimmer switch is typically capable of handling several hundred watts.
Most fan control switches are designed to work with electronics in the fan. It is highly unlikely that you can use a fan control switch as a dimmer on a conventional light. Would have to know much more detail to comment further.
You need a three way switch to control lights from two locations. The name is misleading. Three way switch refers to the connection points on the switch. You can use a three way switch as a single switch as long as you place hot wire on the brass screw and the use any of the other screws for the return hot.
Remember that dimmers are for incandescent lights only unless you invest BIG BUCKS on dimmable fluorescent lights and fluorescent dimmers. Make sure that the switch that you replace with the dimmer does not control a plug-in outlet unless it is a lamp. You could do harm to an appliance not designed for such use. Otherwise,just add up the wattage of all the bulbs on the dimmer and buy one of the next size rating. So if you have two 60 watt bulbs, two 75 watt bulbs-- that's 270 watts total.Find a dimmer rated for 300 watts or more.
The regular switch just connects in the circuit the same way as the dimmer switch came out. If the dimmer switch had its own wires the only difference will be is you will have to supply your own wires from the new switch to the existing connection. IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOBSAFELY AND COMPETENTLYREFER THIS WORK TO QUALIFIED PROFESSIONALS. If you do this work yourself, always turn off the power at the breaker box/fuse panel BEFORE you attempt to do any work AND always use a meter or voltage indicatorto insure the circuit is, in fact, de-energized.
White is for neutral on the fan, black is power for the motor, and red is power for the light. If the power from the switch only has two wires (black and white), you would hook up white to white and hook black and red from the fan to the black wire from the wall switch. This means that you'll be powering the fan and light on the same switch and to change the fan and light separately you will have to pull on the chains or use a remote control.
we use 2-3way switch and 1-4way switch
No
Look on the carton that the dimmer comes in. On the label there will be a list of lamp types that the dimmer can be used on along with the maximum wattage that the dimmer can control.
No a switch just opens and closes a circuit. A switch can be replaced by a dimmer switch. The dimmer switch will fit in the same enclosure that the switch is removed from.
You would have to use a dimmer switch I would think.
The high/low beam dimmer switch is located on the floor by the pedals.
It was not designed to be used with a dimmer switch. You must have a halogen designed for use with a dimmer or it will not work.
Yes
You need a three way switch to control lights from two locations. The name is misleading. Three way switch refers to the connection points on the switch. You can use a three way switch as a single switch as long as you place hot wire on the brass screw and the use any of the other screws for the return hot.
No. this is because a dimmer switch increases resistance to produce less light. in other words, the dimmer switch converts the electrical energy into other forms such as heat by increasing resistance and is thus not saving energy, but wasting it.
If the wattage load is higher that the rating of the dimmer switch then do not use the switch on that circuit. The manufacturer's components of the switch are only rated at a specific rating. Going higher than that rating will destroy the device and void any warranty that the switch might have. Always size the device to the load that you are wanting to control.
Compact florescent do not dim. They are all or nothing. You can use them where you have a dimmer switch. They will come on from about half way to full on. Dimmer switches don't like them and the switch will burn out faster.
You cannot use most fluorescent lights with a dimmer. Just about any incandescent bulb WILL work with a dimmer. Occasionally, when a halogen bulb burns out, it will destroy a dimmer switch but halogen bulbs are considered incandescent and other than that little problem they work well with a dimmer.