Surface tension.
it is probably called figure it out, it is curved because glass is sticky. When you measure the volume from a graduated cylinder, measure at the bottom of it. It is called the meniscus.
Technically, No. Water in a glass (or other vessel) has a curved surface known as a meniscus. A large body of water (like an ocean) actually follows the curve of the earth. So the surface of the water is a curve or section of a sphere.
That depends on the composition of the container, the method of adding heat to thecontainer, the rate at which heat is added to the container, the air pressure abovethe surface of the water, the relative humidity of the air above the surface of thewater, and the rate at which the air above the surface of the water is in motion.In general, the time required, in minutes, is(90)/(the rate of evaporation achieved, expressed in cubic inches per minute)
The exact volume of water cannot be determined because we don't know how deep or high the container is but it would have a surface area of 396 ft2.
One quart
convex
This is called the meniscus. The meniscus is caused by the high surface tension of water.
The meniscus - the upward curve of a liquid in a narrow vessel.
The meniscus - the upward curve of a liquid in a narrow vessel.Read more: When_water_is_ina_container_the_surface_of_the_water_is_curved_this_curve_is_called
The meniscus - the upward curve of a liquid in a narrow vessel.Read more: When_water_is_ina_container_the_surface_of_the_water_is_curved_this_curve_is_called
The meniscus - the upward curve of a liquid in a narrow vessel.Read more: When_water_is_ina_container_the_surface_of_the_water_is_curved_this_curve_is_called
The meniscus - the upward curve of a liquid in a narrow vessel.Read more: When_water_is_ina_container_the_surface_of_the_water_is_curved_this_curve_is_called
Adhesion is the property of water causes the curved surface
it is probably called figure it out, it is curved because glass is sticky. When you measure the volume from a graduated cylinder, measure at the bottom of it. It is called the meniscus.
The surface of a Roman road was curved to make water run off.
kk
Meniscus is the curve at the surface of a liquid in a cylinder. It is caused by the adhesive and cohesive properties of water molecules. (Meniscus was incorrectly spelled in an earlier answer as "miniscus.")