Best Answer

Need to remove the tailgate inner trim panel on hatch and estate car.The lamp is held on by two clips (estate)or two screws(hatch)the wiring needs a couple of ties undoing to remove the lamp.

User Avatar

Wiki User

โˆ™ 2006-04-16 21:02:22
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you get to the 3rd brake light of your Astra mk4 to attach a chrome A S T R A sticker?
Write your answer...
Related questions

How do you fix Vauxhall Astra hand brake cable?

how do you fix a vauxhall astra hand break cable

How do you change the front brake pads on a vauxhall astra?

How do I change the front break pads on a vauxhall Astra

Vauxhall astra stoplights not working?

If none of the brake lights are working i would suspect the brake switch at the brake pedal.

What does the brake caliper attach to?

The steering knuckle.

Astra brake lights are stuck on?

Brake light switch has most likely come adrift from it's fitting

Where is the diagnostic socket in a 2006 vauxhall astra?

On a 2006 Vauxhall Astra, the diagnostics socket is located below the hand brake lever, under the cover. The Astra has been around since 1979.

What brake pads for chrome disc rotors?

Are you sure the rotors are chrome. If they are chrome plated, the plating WILL wear off. They may be made of a Chrome Moly steel.....which is typical for rotors because of it's strength.

Who would have a bumper sticker that says I brake for bilinguals?

A foreign teacher

How do you change Holden Astra front brake pads?

You can change the brake pads by first removing the wheel. Remove the brake and retaining springs. Reverse the process to install the new brake pads.

Why do brake lights stay on when you turn headlights on on your Astra?

the brake lights are on a separate cuircut,if your brake lights are staying then it will be a fault with the brake light switch. the switch is located under dash,and will be on or very close to brake pedal.

Where is the obd port of opel astra 1.6 ecotec?

On the Astra G (1998-2003) it is under a cover in the center console under the emergency brake handle.

How do you remove a front brake caliper on a 1995 dodge neon?

two bolts in the steering knuckle and the brake line are all that attach to the brake caliper

Vauxhall Astra van brake lights are not working and its not the fuses what could be the problem?

Check the bulbs. If these are OK it could be the switch on the brake pedal arm.

What is a Vauxhall Astra?

its on Kele and Rutherford road.they r not good cars they brake own easily i had one

How can i get more slack on the emergency brake cableso i can attach it to the front cable on a 93 ford f350?

remove rear brake drums

Why souldnt you use clear brake pads with chrome rims?

it doent grab rite on the rim

What is the chrome lever behind the gear shift that goes up or down on Jag s type?

It's the electronic hand-brake or parking brake lever.

How do you put an automatic Astra TS sedan into neutral when the engine is not running?

Most automatics require you to depress the brake pedal.

Where is the Diagnostic Port on Vauxhall Astra Mk 4?

under the hand brake housing inside the car just pull the plastic cover between the gear lever and the hand brake and it is under that

What does an exclamation warning light mean on opel astra dashboard?

Trying to find out myself. I think it means the hand brake is on. Doh!

Where do you put the clutch fluid in your astra estate 1.7 diesel?

Astras usually share brake fluid with the clutch fluid resiviour

How many miles can you expect before having to change brake pads on a Astra?

depends on your driving really, but once a year to be safe.

What lines are attached to the master cylinder?

Brake lines and/or clutch line depending on vehicle. For brakes, the front brake lines usually attach to the frontmost connection, and the rear brake lines attach to the rearmost connection. Also of note, the front brakes typically connect to the largest of the two master cylinder reservoirs (normally the front one).

On a 1998 Ford Taurus do the rear brake calipers screw in or push in?

AnswerIf the emergency brake cables attach to the calipers SCREW INIf the emergency brake cables are separate, they PUSH INSee "Related Questions" below for more

Clogged brake line repair?

To fix a clogged brake line, first find the clog. Then, remove the clogged line from the cylinder. Attach a new line, and pump the car's brake to test it before driving.