The link does not work so it is not possible to answer the question.
To determine the equivalence point on a titration curve in Excel, you can identify the point where the slope of the curve is steepest. This is where the concentration of the titrant is equal to the concentration of the analyte being titrated. You can use Excel to plot the titration data and calculate the derivative of the curve to find the point of maximum slope, which corresponds to the equivalence point.
The turning point in a plot is the climax.
There is no such thing as a general pattern. Depending on the variables and the relationship between them, you can have points all over the plot, exactly on a straight line or a curve, or close to such a line or curve.
To draw a sublimation curve, plot temperature on the x-axis and pressure on the y-axis. Follow the curve that shows the conditions where the substance transitions directly from solid to gas without passing through the liquid phase. The curve slopes upward as pressure increases, indicating the sublimation point.
plot of conductor sag and span lengths
A circular plot has many of the same characteristics of a linear plot, except that a circular plot typically begins and ends in the same or similar place. A character would go through the entire journey of resolving the dramatic question only to end up right back where they started, with nothing solved.
Approximately 1,719.27 feet, assuming the plot is perfectly circular.
EOQ point is -(NOT)_ the same point of intersection.in most cases it is the intersection of (setup cost and purchase cost). caring cost is notwithin the curves because it is liner with total carve. Remember caring or ho;dong cost is per unit item per cycle.EOQ is the Min of (sum of two curves setup cost and purchase cost), even if Not the intersect point.in other word1) plot setup cost (Q)2) plot purchase cost (Q)plot the sum of ( 1 and 2) into curve one new curvefind the minimum point in this curve. this point is your EOQ.
You should use a curve if the scatter plot shows a clear curving shape. Otherwise draw a straight line. But a line of best fit should never zigzag from point to point.
A torque curve is a plot of torque produced vs RPM, as measured on a dynamometer. It usually is not linear (a straight line).
1- Linear plot: Straight forward plot. 2- Cicular plot: the plot begins in one point & goes back to the same point in a circle.
When you plot a point you are using coordinates to find a certain point on a grid. In fiction, a plot point is an event in the exposition which will have ramifications later in the story.