0
foot drop is caused by nerve damage & can be treated w/splints, & possibly surgery, but is a permanent otherwise.
Wiki User
∙ 15y ago
Wiki User
∙ 11y agoi have had foot drop for 4yrs now, when i had my daughter back in 2008 is when it started and ive done everything and still have it today.. cant hardly walk right, and cant run at all..
Add your answer:
Earn +20 pts
What items are a foot long?
My foot
Is a foot actually a foot long?
If your foot is twelve inches long then yes it is. The word foot was used to establish the measurement "a foot" because it is the approximate size of a mans foot.
How long is a half of a foot?
A half of one foot is six inches long.
How do i know how many inches i need to drop IN one linear foot to gain a four percent slope?
Since one foot is 12 inches a four percent slope is .04X12 = 0.48 inch drop
How much drop PER FOOT needed for 300' of pipe?
Drop per foot doesn't care about length of run, it depends on pipe size. Pipe larger than 2" needs only 1/8" per foot (37.5" fall for 300'), 2" and smaller needs 1/4" per foot (75" fall for 300')
What are the best exercises for foot drop?
Cycling is best exercise for foot drop.
Will foot drop caused by a fragmented herniated disc go away?
I had a herniated disc in the L5 S1 region that burst and fragmented...surgery went well but I am left with drop foot...will I regain full use of my foot...if so, how long will it take?
How long will egg drop soup last in the fridge?
I think it would last just for a day.
How do you figure quarter inch drop per foot?
Use a level which is at least a foot long. Hold the level in the horizontal level position, and measure the 1/4" drop from the position of the level which is one foot from the end. If you have a four foot level, and the space to use it, you can easily measure one inch of drop per four feet, which is the same as 1/4" per foot.
In order to treat foot drop are foot orthotics worn 24hrs a day?
Yes, the best foot drop orthodic to use 24hrs is the Soft Foot Drop Brace at http://store.grandviewmedical.com/foleknsu.html There are also other solutions but if you have a foot drop problem you need some type of orthodic to help you walk.
What are some of the typical symptoms of having a drop foot?
Foot drop often affect the muscles which are responsible for the ankle movement. Some typical symptoms of having a drop foot are limp foot, numbness, difficulty with certain activities and tingling.
How long does it take to get from the top of drop zone to the bottom of drop zone?
The whole ride takes about 44 seconds. The drop problably last for a bout 3-5 seconds.
What is the Opposite of drop foot?
its hold
What is a th difference between solids and liquids?
Take a block of frozen water (ice) and drop it on your foot - ouch!. Then drop the same amount as water on your foot. I know I would prefer to drop water on my foot that solid ice.
How fast is Mantis at Cedar Point?
Mantis has a top speed of 60 mph. It has a 137 foot drop and last 2 minutes and 40 seconds.
Will a water balloon drop from 6 feet make a larger splat than a water balloon drop from 1 foot?
1 foot
What is voltage drop per foot?
Voltage drop is caused by resistance. From the equation V=IR the voltage across that resistance can be calculated. For a uniform conductor the resistance is linear with the length R=kx where k is in ohms per foot. For a given current, the voltage drop V=Ikx so the voltage drop per foot is Ik. Voltage drop per foot can be measured, allowing a calculation of voltage drop for very long lengths of conductor such as power transmission lines. This is a reasonable approximation as long as the total voltage drop in transmission is small relative to the supply voltage. If the voltage drop is large, the current will be limited by the total resistance. This implies that long distance transmission lines should be high voltage, because 1 megawatt at 10,000 volts requires 100 amps, while at 100,000 volts it only requires 10 amps. The voltage drop per foot for the same conductor would be 10 times as large at 10 times the current, and the power loss (I*IR) would be 100 times as large. For alternating current, inductance can be a factor; this implies that relatively low frequency would be preferred.
