মোবাইল নাম্বার 01999103997
800 pounds of water would be 95.8 US gallons.
That depends on the type material you are referring to. Also, these are two different types of measurements. Gallons is a measure of volume but the other is weight or mass. Please edit your question to include more context or details.
they are both equally hot, but the5 gallons of boiling water has more energy. If I had a choice of "boiling water torture" technique that would be used on me, I'd take the "5 drops" option. Still 100 degrees centigrade, but much less heat energy.
this depends on the initial and final temperatures...
7,500 gallons of water equates to 1,002.604 cubic feet. This much water would have a weight of about 62,625 pounds.
how hot is the boiling water? That makes a big difference? (is that a homework question?) I'm just trying to apply logic here, bear in mind there may be some special properties that you may have to account for like the glass/plexiglas that the water is in will have to have its temp raised also. So here goes... Raising 500 gallons of water 20 degrees would seem to require a combined value of 10,000 degrees (500 gallons times 20 degrees). So first you need to know the temperature difference between the existing water and boiling. Then devide the resulting difference into the 10,000 degrees for your simplistic answer. However, it is a bit more complicated if the tank is full at 500 gallons because you have no room to add the boiling water. That is, it would roughly take 62 gallons of boiling water to raise 500 gallons of 50 degree water to 70 degrees and the tankwouyld obviously overflow. So if it was already full you would have had to remove 62 gallons first leaving 438 gallons and consequently reducing your degree needs to 8760 degrees which means if you add the 62 gallons of boiling water you would have ended up with 72.7 degree water. So, I'd reduce the capacity to 445 gallons and add 55 gallons of boiling water and you should be pretty close.
form_title=Water Heater Repair form_header=12213 Choose any description for the problem*= [] No hot water [] Not enough hot water [] Pilot light is out [] Leaking tank [] Hot water fluctuations [] Leaking or cracked pipe [] Making noise [] Want to move to other location [] Want to replace with different type [] Other Do you know the size of your water heater you have now?*= () 30 Gallons () 40 Gallons () 50 Gallons () No water heater () Other "If a replacement is required, would you like the same type?"*= () "Yes () No, I want a different size () No, I want a tankless water heater () No, I want a solar water heater () No, I want to change to electricity () No, I want to change to natural gas () No, I want to change to propane gas () Don't Know" What is the source of heat the water heater is using?*= () Electricity () Natural gas () Propane () Don't Know
If you are referring to imperial gallons, about 45 inches tall.
Suppose G gallons are used. Before mixing, you have 5*65 + G*120 = 325 + 120G gallon-degrees. After mixing, you have (5+G)*70 gallon-degrees So 325 + 120G = (5+G)*70 = 350 + 70G So 50G = 25 G = 0.5 gallons.
It is a water heater, not a hot water heater. There would be little point in using a hot water heater. I assume that is your point.
800 pounds of water would be 95.8 US gallons.
The number of pounds in a gallon of water changes with temperature. At 100 degrees Celsius, there is about 8 lbs. per gallon of water. So with one thousand lbs. of steam, we would have around 125 gallons of water.
Of course a water heater thermostat would be defective as water heaters / hydronic boilers would use an Aqua Stat
Of water no. Water would be about 32 pounds in 4 gallons.
Five gallons of sand would actually weigh more than five gallons of water.
about 100 lbs
Check that there isn't water around the water heater first, which would mean that turning it off and closing the water valve would be a good idea. Then, check the fuse box to see if the power has tripped--that is if it is an electric water heater.