It depends on a lot of factors. Since you will have to get an electrician involved you should start there. It is likely that you can double the capacity, but the electrician would consult with your power company to determine what is possible. I recently went from 200 A to 400 A service with a large addition; and a transformer was required in the house with rework of the two panels I already had into 5 panels.
i have required lightings amps rating, how many circuit ku how much amps mcb fixing?
If the mains is a 200 amp two pole breaker each leg can carry up to 200 amps in relationship to the common neutral of the service.
AWG 4 copper.
The wire size used in a service entrance distribution panel is governed by the size of the services over current device. The larger the service, the larger the fault current could be, the larger the ground wire to carry the fault current to ground. If the largest service conductor carries 100 amps use a #8, 200 amps - #6, 400 amps - #3, 600 amps - #1, 800 amps - 1/0 and over 800 amps - 2/0 for the ground wire. <<>> Golden Valley Electric Assoc. in Alaska requires #4AWG copper wire for a ground from the breaker box to earth ground rod. The same goes from the service entrance panel on the pole.
Amps * Volts = Watts So, Watts / Volts = Amps 2000 / 240 = 8.333 Amps You should run the circuit on a two pole 15 Amp breaker, using 14 AWG, 2 conductor (plus ground) wire, just so you have a little safety factor in the circuit size.
A 200 amp service panel is average for the entire U.S.
200 amps is the average
The maximum distance of a wire drop between a service pole and service connection is undefined, as it depends on many factors not included in the question. The information needed to actually compute such a distance includes, but it is not limited to, the service volts, the service Class (60, 100, 200, 400 or more amps), and whether or not the drop involves a mid span tap -- that is, the service is actually connected not to a pole, but it is connected to secondary wires between two poles. <<>> A utility company will usually bring their service a maximum of 100 feet on to private property.
i have required lightings amps rating, how many circuit ku how much amps mcb fixing?
If the mains is a 200 amp two pole breaker each leg can carry up to 200 amps in relationship to the common neutral of the service.
It its rating is 63 amps that means the current can be anything from 0 to 63 amps but not more.
none is magic
no there is phone service in the north pole
Add another leg of 120 to a three pole breaker.
AWG 4 copper.
The wire size used in a service entrance distribution panel is governed by the size of the services over current device. The larger the service, the larger the fault current could be, the larger the ground wire to carry the fault current to ground. If the largest service conductor carries 100 amps use a #8, 200 amps - #6, 400 amps - #3, 600 amps - #1, 800 amps - 1/0 and over 800 amps - 2/0 for the ground wire. <<>> Golden Valley Electric Assoc. in Alaska requires #4AWG copper wire for a ground from the breaker box to earth ground rod. The same goes from the service entrance panel on the pole.
This is a voltage drop question. To answer it, a voltage of the service and amperage that the service is going to be have to be stated