Want this question answered?
It is an accepted fire service understanding that 5" Large Diameter Hose (LDH) will hold 1 gallon/ft. On average a 100' section of 5" empty weighs 110 lbs. With water weighing 8.33 lbs/gal. a 100' section of LDH filled with water will weigh approximately 944 lbs.
50 feet
you need more info than that. you will need to provide the length of the hose and the inside diameter of the hose to calculate the amount of water it will hold
Depends on the hose, obviously different hoses weight different amounts.
There need not be any water at all in the hose! The capacity of the hose is 1.67 cubic feet.
Weight of 50ft section of 3 inch hose with water in it?
It is an accepted fire service understanding that 5" Large Diameter Hose (LDH) will hold 1 gallon/ft. On average a 100' section of 5" empty weighs 110 lbs. With water weighing 8.33 lbs/gal. a 100' section of LDH filled with water will weigh approximately 944 lbs.
A hose which lets out a very strong amont of water.
That section of hose holds 25.5 gallons of water when it's full, which weighs about 213 pounds. To that, add the weight of the empty hose, which I don't know.
109 lbs with no water
A fire hose is used to stop a fire by its ability to transfer water. The hose will deliver water from a source through a nozzle and onto the flames. We typically find a hose connected to a pump, which provides water under pressure. The hose will deliver that pressurized water to the nozzle, and a firefighter can direct the stream as needed.
50 feet
2+ ppl
A garden hose as a means to get water, yes. A fire hose, no.
If it's full of water, then the water in it weighs about 106.5 pounds. I have no way of knowing what the empty hose weighs by itself. Whatever it is, you'll need to add that to 106.5 pounds.
you need more info than that. you will need to provide the length of the hose and the inside diameter of the hose to calculate the amount of water it will hold
There are many different types of fire hoses, but the type you're probably picturing is called an "attack hose" that's the hose that takes water from the pumping system to the nozzle. It's the business end of the operation. The typical attack hose is 1530 cm long and has an inner diameter of as much as 7.6 cm. The volume of a hose is the length of the hose, times the area of its circular cross-section. With an inner diameter of 7.6 cm, an attack hose has a cross-section of πr2=3.14*3.8^2= 45.34 square cm. So, the volume of water in a full attack hose is 1530*45.34= 69370.2 cubic cm. That's about 18.32 gallons.