Answer for USA, Canada and countries running a 60 Hz supply service.
It is a violation of code. When pouring concrete there is often a lot of pressure, not to mention boots, placed on wireways in the pour. This could cause the coil of the bx to separate, exposing the conductors to metal edges and to the chemical reactions of the concrete.
<><><>
As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.
Before you do any work yourself,
on electrical circuits, equipment or appliances,
always use a test meter to ensure the circuit is, in fact, de-energized.
IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOB
SAFELY AND COMPETENTLY
REFER THIS WORK TO QUALIFIED PROFESSIONALS.
Yes, you can run electrical wires in a load bearing wall.
Yes, it is perfectly safe. An outlet is just a place where electricity is available when you need it. It can do you no harm whatsoever by sleeping next to it any more than sleeping next to a electrical cord plugged into that outlet and then run up to a lamp or clock next to your bed. I assume you are worried about the magnetic field created. This field is so low that it is barely detectable at an outlet.
Run, run and just keep running!
n you run thhn wire in a cable tray
Armoured cable is not rated for underground installations. You have to use a cable with a designation for direct burial or wet and damp locations.
The speedo cable on an 87, usually is an electrical hook up, in which case is run by wires, to an output on the tail shaft of the transmission. Mine on the other hand is cable, because I changed it, therefore the cable hooks up the back of the gauge cluster.
0.5 Metres roughly
it is safe to do so long as no mechanical damage can take place to the cable and that no human contact can be made to it,it needs to be in condute and well strapped to the wall,and it is wise to fit a r.c.d protection device.Thats what we do in Australia.
Yes as long as the building construction is using wood wall studs.
Duck Run Cable Suspension Bridge was created in 1922.
The outer casing of an Ethernet cable does not have a UV rating and will deteriorate under the summer sun. Pull the cable into a conduit and if possible bury the conduit underground. This will give you a safe and secure link.
Yes, you can run electrical wires in a load bearing wall.
Yes. It is a myth that a battery will run down sitting on concrete.
If it isn't going parallel to the electrical wire, coax should be able to shield against simply crossing over the wire. Just don't follow the electrical wire for more than a couple feet.
Electrical- there are a few that run on heat energy from gas or kerosene.
Yes, it is perfectly safe. An outlet is just a place where electricity is available when you need it. It can do you no harm whatsoever by sleeping next to it any more than sleeping next to a electrical cord plugged into that outlet and then run up to a lamp or clock next to your bed. I assume you are worried about the magnetic field created. This field is so low that it is barely detectable at an outlet.
Backbone cabling