Want this question answered?
Info can be found here http://www.allpar.com/fix/80s-codes.html26 Peak injector circuit voltage has not been reached (need to check computer signals, voltage reg, injectors) (SEE NOTE #4 BELOW)NOTE #4.During cranking, the computer will test the current through the injector to see whether there's too much resistance in the injector's path. If there is, code 26 is set.The problem may be cured with tuner cleaner on the connectors.For TBI engines, the injector's cold resistance should be between 0.9 and 1.2 ohms (specs vary with year). This is a peak-and-hold injector. With the engine idling the peak period should be about 1.2 milliseconds whereas the hold period will vary. If it's lower than this at idle, then the injector's shorted or there's a defect in the injector driver circuit. (Bohdan Bodnar)
I would check your spark plug first, then I would go to the injector. This happend to me and it was the injector.
In a company balance sheet.In a company balance sheet.In a company balance sheet.In a company balance sheet.
balance scale balance things. oan scale dosent
An opposite of balance could be 'imbalance'.
73l
flamingo balance, balance board test, one legged stand, standing balance test
Magnetic balance test is performed on transformer to check, whether the core and windings of the transformer is balance position or not. Magnetic Balance is a test of Critical use as it helps us to enhance the efficiency and life of transformers.
To test the validity of an account balance.
when ignition is on it should be battery volts,when cranking in should pulse..(test with a led test light or osilliscope
I had to replace the injector itself the other day as it was not allowing the fuel to go into the TBI unit. I used the injector test light on the harness and it show the computer as being good.
you have to remove the high pressure oil manifold, then remove the fuel injector.
The Magnetic Balance test is conducted on Transformers to identify inter turn faults and magnetic imbalance.
check plugs, wires, or coil packs. on cylinder #5. But if your changing plugs or wires do them all at one not just #5. ------------------------- Dont forget to check the Fuel Injector also. You can test the injector by swapping the # 5 injector with the injector from any other cylinder. If the miss changes cylinder then the injector is bad.
if you have the wii you can find your self doing balance test and or strength test.
The performance test on a machine
test