answersLogoWhite

0


Best Answer

No, just a light adaptor strap that goes diagonally across the box. They're cheap, under $1.00.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: I have a horizontal junction box with holes on either side to screw in light fixture. Bought a light fixture and the holes do not match up. Do I need a different shape box?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Natural Sciences

Why does an energy saving light bulb with a light sensor stay on in daylight?

The sensing unit on the fixture is thinking that it is night time. If your fixture has a switch before the light, that has to be left on for the sensor to work, try the following. Turn the fixture off with the switch and leave it off for about ten minutes. Turn the switch back on and the fixture will turn on. If the sensor circuitry is working the fixture will turn off after your "delay on" setting is reached. If there is no switch before the fixture check to see if the sensor has been covered, fooling the sensor into thinking it is night time. If it is a hollow tube type sensor, sometimes hornets will lay an egg in there and cover the sensor with a mud patch. As a last resort change the sensitivity control so that is senses daylight sooner, allowing the sensor to shut off earlier. If none of the above work its time to buy a new sensor. These can be bought individually and installed into the old fixture.


How do you change a fluorescent bulb?

Ok I bought an apartment with a recessed light fixture in the shower. The bulb blew out and its been driving me nuts trying to figure out how to fix it, but I finally figured it out. The lens cover sits absolutely flush against the ceiling. I put my fingernails beneath the rim of cover (around the outside of the fixture between it and the ceiling) and pulled straight down as hard as I could. I thought I was going to pul the entire fixture out of the ceiling, but instead, the lens cover finally lowered. It was held on by a pair of U-shaped springy wires that put pressure on the inside of the lighting fixture and holds it in place. So pretty much, to remove the lens cover, I had to pry it off. Then once I changed the bulb, I simply pushed the cover back in place


Where can Wirefly cell phones be bought?

The Wirefly cell phones are able to be bought at several different online and retail locations including the following stores: Amazon, eBay, and the Wirefly website.


Is there a distance limit for conduit runs between junction boxes?

No, there is not a distance limit. Most prints have specified 200' and local jurisdictions may impose a limit. The largest fish tape I've ever bought was a 200' so unless I want to vacuum a 'mouse' through the pipe; I go with 200'.


Where can one buy a travel clock that adjusts to different time zones?

A travel clock that adjusts to different times zones can be bought from many places. The best places to get them from are from watch manufacturer companies.

Related questions

What is a sentence for a conjunction?

I went to the store and bought some groceries.


Bought a new light fixture and light bulbs It has 3 bulbs Why do they only stay on a minute and go out?

Check your kids playing with the light switch


Can you use a 300 volt consumer LED light fixture in your 120 v residential system?

No but it is not clear where 300 v consumer lights can be bought anyway.


What changes are to be made for a fluorescent lamp circuit to work if ac supply is replaced by dc?

A fluorescent light fixture is designed to operate on an AC voltage supply. To have the fixture operate off of a DC supply a power inverter would have to be installed. The power inverter would then change the DC to AC for the fixture to operate. These power inverters are reasonably priced these days and can be bought at most DIY stores.


What is a catering sink used for?

A catering sink is a large sink used for catering or other large event where a bigger sink is needed. These sinks are mobile and can be bought from Atlanta Fixture and Sales Company.


Why does an energy saving light bulb with a light sensor stay on in daylight?

The sensing unit on the fixture is thinking that it is night time. If your fixture has a switch before the light, that has to be left on for the sensor to work, try the following. Turn the fixture off with the switch and leave it off for about ten minutes. Turn the switch back on and the fixture will turn on. If the sensor circuitry is working the fixture will turn off after your "delay on" setting is reached. If there is no switch before the fixture check to see if the sensor has been covered, fooling the sensor into thinking it is night time. If it is a hollow tube type sensor, sometimes hornets will lay an egg in there and cover the sensor with a mud patch. As a last resort change the sensitivity control so that is senses daylight sooner, allowing the sensor to shut off earlier. If none of the above work its time to buy a new sensor. These can be bought individually and installed into the old fixture.


Where can waterless urinals be bought?

Waterless urinals have advantages over traditional urinals such as a lower cost and benefits to the environment. Waterless urinals can be purchased at places like Fixture Universe, ZORO Tools and Amazon.


What is the range of price on an industrial light fixture that can be installed in a garage?

The price range for industrial lighting fixtures can be from seventy dollars to nearly three hundred dollars. It depends on what kind of fixtures are desired and where they are bought from.


What is a horizontal integration monopoly?

A company that tries to control the competition in a single step of the production process. :>


How do you update an app with a different account then what you bought it with?

You can't.


Where can a premier bath be bought?

A premier bath can be bought in a number of different stores. One store is Lowe's, as they always carry a bunch of different baths, including premier baths.


Wii dance mat how to connect it?

Hi!!, if you put the console horizontal there is a large flip on the left side of the power button where you can plug 4 different gamecube controllers, just open the flip, plug it in and power up. Hope this can be useful, it took me a while, even returned the first mat I bought.