0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you drill a five sixteenth inch hole four inch depth flat bottom hole?
5/16 hole X 4 inch on a flat bottom hole: This will depend on the material, and tools available. Use a 1/8 bit, then 5/16. If you are not sure how deep the drill bit is in the hole, paint white out on the bit as your 4 inch mark so you can see it while the drill is spinning. If the material is metal, you will need coolant. To get the flat bottom: it wood, put a flat ended bolt into the hole and hammer, it will flatten the hole, it metal, forget about it, the hole is quite flat, and a pain in the butt to change. :-)
How many quarts of an inch in half inch?
Two quarters of an inch are in a half inch.
How much dirt is in a 1 inch by 1 inch by 1 inch hole?
Since it is a hole, it doesn't have any dirt. But it has the capacity to hold 1 cubic inch.
How do you write half inch?
1/2" Or Half Inch of 50% of 1 inch
How many feet and inches are in a half a inch?
there are 1\24 of a foot in a half an inchthere are 1\2 of an inch in a half an inch
Could you use a .38 inch bit to make a pilot home for a 5 mm bolt?
No, it is way too big for a pilot hole as 5 mm = 0.20 inch which is smaller than .38 inch
If you have a half inch threaded bolt and trying to thread into a mm hole it almost fits but stops after a couple turns what size mm bolt do you need?
12mm is a little smaller and 13mm is a little larger than a 1/2 inch bolt.
An automotive bolt has a designation of half inch 13 UNC auto technician A say htis bolt is coare thread bolt auto technician B say the bolt has a diameter of 13 millimeters what sta?
A, the half inch bolt has 13 rows of thread in one inch.
What size drill bit do i use for a one quarter inch bolt?
If you want the bolt to slide through the hole a 5/16 hole will work well.
What socket size for half inch bolt?
1/2"
How do I drill a half inch hole in sandstone?
by using a drill
What hole size do you use for a bluebird house?
The entrance hole on bluebirds should be 1.5 inches.
What is wheel bolt pattern on 1940 Ford truck?
5 hole x 5.5 inch bolt circle on 1/2 ton
What size bolt connects the brake line to the brake caliper on a 1987 suzuki samurai?
The size is probably an half inch bolt to 3/4 bolt.
The holes should be at least one half inch deeper than the length of the bolt?
True
Will a jeep wheel fit a 1999 F150 truck?
no, half inch difference in bolt pattern
Where do you put the transmission fluid on a manual 1990 Nissan 300zx?
The transmission fluid, or gear oil, filler hole is located on the side of the transmission. It is a round bolt just bigger than a quarter with a half inch square indentation. Use a half inch braker bar to get it loose. The drain plug is the same bolt located on the bottom of the tranny. I suggest you check your rear diff. fluid as well since you'll be under your car.
