answersLogoWhite

0

What angle should fire cut be?

User Avatar

Anonymous

13y ago
Updated: 10/17/2024

Depending on size of masonry above the beam the depths of cut shall be equal to the thickness of the beam, or equal the embedment depth of the beam into masonry. Rule of thumb - 2"

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What is the angle of a fire cut of a floor joist?

30 degrees


What angle do cut a polygon?

Any angle can cut a polygon.Any angle can cut a polygon.Any angle can cut a polygon.Any angle can cut a polygon.


What angle should a stem be cut at?

45 degrees


What angle should I cut crown molding at for proper installation?

To properly install crown molding, you should cut the angles at 45 degrees.


What is mean of fire angle?

the fire angle is the angle at which the thyristor starts working...


What angles should be used to cut crown molding?

When cutting crown molding, two angles are typically used: the miter angle and the bevel angle. The miter angle is the angle at which the molding is cut horizontally, while the bevel angle is the angle at which the molding is cut vertically. These angles will vary depending on the type of crown molding and the corners being joined. It is important to measure and cut accurately to ensure a proper fit.


What should you do if a boat motor catches fire?

cut of fuel supply


After measuring you decide the naspharyngeal airway is is to long what should you do?

cut it to the correct length, creating an angle


What degree of angle do you set a table saw to cut a 8 sided octagon?

To cut an 8-sided octagon, you should set your table saw to a 22.5-degree angle. This is because each internal angle of an octagon is 135 degrees, and the angle for the saw blade should be half of the exterior angle, which is 45 degrees. Therefore, cutting each side requires a 22.5-degree bevel.


How do you cut a 135 degree angle?

Cut a 45 degree angle "going the other way".


What is a crown cut when you cut wood?

When you say "crown cut" I think you are referring to a compound angle cut. A compound angle is 2 angles cut at the same time. In crown for instance you put the trim in the saw at a 45 degree angle, and tilt your saw blade at a 45 degree angle as well.


Why should a stem be cut at an angle during a transpiration experiment?

So that there is a bigger surface area exposed.