It is a fixture that has a hermetical seal that keeps fumes and vapours from the electrical parts of the fixture. A good example of a vapour tight fixture is one that is used in paint spray booths. These types of fixtures are not to be confused with explosion proof fixtures which are in a different category altogether.
A fixture or device that holds a light in place by means of some sort of socket, that is connected to a power source.
A pin based fluorescent light fixture is the type of fixture that takes fluorescent tubes. On each end of the fluorescent tubes there are contact pins. These pins are used to hold the tube in the fixture and to supply the voltage to the tube from the fixture's ballast.
The wire nuts do not have to be inside the junction box. They must, however, be as tight as possible to keep moisture from inside the light fixture.
it will explode
Extra wires to a light fixture are dangerous. It can cause electrical shock when having contact to people therefore it must be guarded to avoid physical contact.
A recessed light fixture with a rubber gasket approved for use in a damp location, e.g. shower light.
Too high wattage for the fixture or screwed in too tight>
Verify that the cap is tight. Drive for a couple of days, and if the light is still on, you have a vapor leak in the fuel system and will need service.Verify that the cap is tight. Drive for a couple of days, and if the light is still on, you have a vapor leak in the fuel system and will need service.
A fixture is what the light bulb goes into.
The correct spelling for a fancy light fixture is "chandelier."
The light is wired the same as any voltage fixture. Bring the source voltage to the fixture and connect it to the two fixture wires. If you want to control the off-on of the fixture take the source voltage to a switch first and then out of the switch to the light fixture.
Take the nut off at the bottom of the light fixture by unscrewing it.
First, remove the inside trunk lid cover panel. Disconnect the electrical connection. Use a spin tight wrench (7mm) to remove the two screws. Unclip and remove the protective cover. Unclip and remove the light fixture. The light fixture is LED so you will need to replace the entire fixture, it's about $60 at the dealership. I just did this procedure last night.
Disconnect the fixture wires and remove the central mounting nut to release the dome from the light fixture in a ceiling fan.
It just holds the bulb, does not have a switch in the fixture.
A lock is a fixture, same as a light, sink, tub. A fitting is usually a part of a fixture, or a fixture is made up of fittings.
If the question is, can I wire a switch to an existing light fixture (and I must assume that it's something like a pull-chain light fixture), the answer is yes.If the question is, "how do I wire a switch to an existing light fixture that has no external switch", the answer is, "in series".The attached web site gives simple instructions on how to wire a basic light switch to an existing light.See sources and related links below