A 10 Gage wire will carry 30 amps. But if you are talking 10 Gage fusible link wire then that's different, a fusible link wire is a delayed fuse & will melt if over loaded.
The general rule of thumb in the automotive trade is use a fusible link wire 2 Gage smaller then the load wire.
If you are using a 10 Gage wire then you should protect the circuit with 14 Gage fusible link. I hope this helps!
That is 10 amp wire.
10
The ampacity or amp rating of all wire is rated by the size of the wire. NM (non-metallic sheathing) wire is no different. In household wiring 14 gauge wire must go on a 15 amp breaker/ 12 gauge goes on a 20 A and 10 gauge goes on a 30 Amp.
Assuming the wiring is sized for 12 amps, you can replace your fuse with any 12 amp fuse or smaller and with a voltage rating at or above what you expect to connect to it. The amp rating protects the wire, so you cannot go above what the wire can handle. The voltage rating is the max voltage that it can safely protect, so you cannot use a fuse with a lower voltage rating than you expect to connect to.
Yes, as long as the amp rating is the same. Examples, 600v 100amp fuse can be used in a 120v 100 amp's location.
That is 10 amp wire.
3Amp
10
50 amp
80 amps
Yes , I believe it is fuse # 17 , a 15 amp fuse for the fuel gauge
try the link give fuse: amp rating: location: and what it powers. good luck. http://www.mirez.co.uk/Fuses.htm
You need to instal the same size and amp rating as you removed.You need to instal the same size and amp rating as you removed.
The ampacity or amp rating of all wire is rated by the size of the wire. NM (non-metallic sheathing) wire is no different. In household wiring 14 gauge wire must go on a 15 amp breaker/ 12 gauge goes on a 20 A and 10 gauge goes on a 30 Amp.
A fuse is given a various rating (strength). For instance, a home appliance (washing machine, etc) would usually have a fuse with a 13 amp rating. While a low powered lamp would only merit a 2 or 5 amp fuse rating. It is important to use a fuse of the correct rating in amps for each electrical appliance.
The purpose of a fuse it to protect the wire that goes to the load. A 15 amp fuse protects a #14 gauge wire. A 20 amp fuse protects a #12 gauge wire. To answer your question if the wire size is #12 coming from the 15 amp fuse now then it can be upped to 20 amp fuse. If it isn't then you are taking the risk of overloading the #14 wire with a 20 amp fuse. This can lead to insulation failure of the #14 wire, overheating with the possible outcome of a fire breaking out somewhere in the circuit.
You can replace a higher rating fuse with a lower rating provided it works with the device without constantly blowing. So try the 30 amp fuse in your lawnmower and if it doesn't blow and the mower works okay, you are fine. If it blows you will have to go back to 40.