answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What is the ampacity of 8 awg cable?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you make 8 AWG stranded electrical cable?

WIRE


What is the correct size of cable to used for 50 amps?

8 AWG.


What is larger 12 gauge wire or 20 gauge wire?

Yes, a #12 AWG conductor has a greater diameter than a #14 AWG conductor. A #12 conductor has an ampacity of 20 amps whereas a #14 conductor only has an ampacity of 15 amps.


What is the ampacity of a 10 sq mm Aluminium wire?

A 10 mm squared conductor is equal to a #8 AWG. A #8 copper conductor with an insulation factor of 75 or 90 degrees C are both rated at 45 amps.


Can 12-2 wire be used where only 14-2 wire is required?

Yes the ampacity of #12 is 20 amps whereas the ampacity of #14 is 15 amps, so you are well within the range using #12 wire.


What is the Max amp on 10MM cable?

Canada and US - 10 mm is larger that #8 AWG and smaller that #6 AWG. To err on the safe side I will use the #6 AWG equivalent of 60 amps, RW90 insulation, copper wire.


What is the wire that comes out of the positive battery cable attachment on my 1990 Isuzu Trooper?

If it's a heavy gauge (around 8 AWG IIRC), that's the charge wire to the alternator BATT post. The larger cable (about 4 AWG) goes to the starter.


What is the awg wire size designation of the cable?

:D


What is the ampacity of a NM-B cable?

Allowable ampacity for 10-2 copper NM-B is 30 A.http://www.cerrowire.com/default.aspx?id=46


What cable for 150 amp Service Entrance Cable?

200 amp service entrance wire should be AWG # 2/0 copper or 4/0 aluminum.


What is AWG in cable?

American Wire Gauge. Measure the thickness of the cable.


Continuous loads are calculated at what percenteage of the connected load?

"... the rating of the overcurrent device shall not be less than the non-continuous load plus 125% of the continuous load." NEC 2008 Article 210.20(A) Furthermore, the ampacity of the conductor must be derated to 80% of allowable ampacity as stated in Table 310.16. Please take note of the exception to the table for #14 AWG, #12 AWG, and #10 AWG in Article 240.4(D) which automatically derates small conductors such as these to 15A, 20A, and 30A respectively. Also be aware of all other ampacity derating that may be required by Article 310 and Article 422.