0
== ==
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What is the Number one cylinder in a 350 corvette?
Number one is ALWAYS the first cylender on the front left side of the engine......
What is the height of a desk chair?
Fixed height desk chairs usually have a seat height about 450mm above the floor. Good adjustable chairs have a range from 350-520mm which allows them to be adjusted to suit 95% of people.
What is the volume of a rectangular prism with a lenght of 10cm a width of 7cm and a height of 5cm?
10*7*5 =350 cubic centimetres.
How much days are in 50 weeks?
350 days.350 days.350 days.350 days.350 days.350 days.350 days.350 days.350 days.350 days.350 days.
What fraction is 350?
350 = 350/1
What carburetor does a 1998 wolverine 350 have?
it has a 34mm mikuni carburetor.
Where is carburetor adjustment screws on 1988 Honda 350 foreman?
The 1988 Honda 350 carburetor adjustment screws are on the side of the carburetor. There also is an adjustment screw on the very top of the carburetor.
How much is a 1975 350 corvette w40000 miles worth?
depends on condition of the car, interior, exterior, crash history, number of owners, etc.
How much horse power did a 1975 350 corvette have?
Base engine - 165 hp (123 kW) L82 - 205 hp (153 kW)
Which was the engine power of the Chevrolet caprice convertible 1975?
The 350 V8 with 2 barrel carburetor produced 145 h.p. and 235 lb/ft of torqueThe 350 V8 with 4 barrel carburetor produced 155 h.p. and 250 lb/ft of torqueThe 400 V8 with 4 barrel carburetor produced 175 h.p. and 305 lb/ft of torqueThe 454 V8 with 4 barrel carburetor produced 215 h.p. and 350 lb/ft of torque
How do you clean a carburetor on a Honda fourtrax 350 ATV?
you have to take out the carburetor and then clean it
What 350 Chevy engine will bolt in a 1979 Corvette?
Most Chevy 350 4 bolt engines will bolt into a 1979 Corvette.
What size motor is in a 90 Corvette?
The 90 Corvette had a 350 c.i. engine
A diagram of a 1981 Corvette 350 motor?
diagram of motor od 1981 corvette
Will a 1969 Corvette 350 block fit in a 1994 Corvette?
Yes, the block will fit.
Where does a pilot bushing go on a clutch rod for a 1975 corvette 350?
The pilot bushing is installed into the rear of the crankshaft. The pilot bushing supports the input shaft of the transmission.
Will a 1969 Corvette 350 eng. block fit in a 1994 Corvette?
Yes, the block will fit.
