0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What Is the take off measurement on a 4inch victaulic 90?
5 inches
What is the take off measurement for 6 Victaulic 22.5 degree elbow fitting?
1-13/16"= The tangent of half the degree X the radius of the elbow.
What is the measurement 111.009mm rounded off to four signifigant digits?
111.0
What is the measurement 1049 L rounded off to two significant digits?
1.0e3L
How do you find the measurement of one side of a parallelogram?
You take your ruler and put it along the edge you want to merasure, line the begining of the scale (0) up with the corner and read off the length at the other corner.
What Is the take off measurement on a 4inch victaulic 90?
5 inches
What is the take off measurement for 6 Victaulic 22.5 degree elbow fitting?
1-13/16"= The tangent of half the degree X the radius of the elbow.
What is pipe take off?
It is the measurement of fittings for piping. It is the measurement of fittings for piping.
How would you take a measurement for a sample of 0.2 mol dm-3 CuSO4 if the reading was off the scale?
no
What is the take off measurement of 45 degree elbow 18 inches pipe?
11 1/4
What is dencity answer?
the measurement off mass
How do you remove the rear inside door handle on door jam of left door on a 1987 Astro?
4 screws in between the 2 doors take off 4inch flat plate look inside 2 10mm nuts and 2 clips on rods comes out easy...
What is take off measurement for 90 degree 8 inch pipe?
The take-off for a standard radius 90 is one and one half the diameter of the pipe. Example: 6 inch 90 has a take- off of 9 inches. The take-off for short radius 90 would be the dia. of the pipe. Long radius 90 is 2 times the pipe diameter.
Is power a direct measurement?
no so screw off
What do they do during a bra fitting?
They measure u with just ur bra on and sometimes they may tell u to take ur bra off to get a proper measurement
Why is levelling important in surveying?
Leveling in surveying is important to get an accurate measurement. The rise and fall of the grade will cause the measurements to be off, resulting in an inaccurate measurement of plots of land.
Can a 307 Chevy be borded to 4inch 350 Chevy v8?
You would have to bore it .125 thousands to get it to a 4" bore. I highly doubt the 307 will take that much of an overbore and survive. Most blocks certainly can't be bored that much. 350 SBC are a dime a dozen. Better off just picking up one.
