Well work out your CSA size from what you got. If you've got the wiring regulations you can look it up there. Takes some time but you'd find most of it in there on what you need.
To calculate voltage drop to size the wire, a voltage must be stated.
35 KVA generator using for load 100 meter length which cable need to used
power factor meters are connected across the supply
pressure coil or voltage coil across the supply and the current coil in series.
the minimum distance between two cable joint 2 meter (refer IEC 60052-4)
find your electric Meter and you've found the point of entry, or depending on where the electric meter is in the building, you can trace the cable back from the meter to the point of entry.
To calculate voltage drop to size the wire, a voltage must be stated.
The main supply will first come from the power company to a transformer to reduce the voltage then from the transformer to the weatherhead then through the house meter to the main disconnect on the outside of building then to the switchgears main. The cable coming from the transformer to the meter and to the top of the main disconnect is the Main service cable
ohmmeter has it's own power supply
It is connected to the cut out fuse which enables isolation of the circuit from the supply when there is a fault.Additional Information:The service cable is usually connected to a meter fixture and from there to the main electric panel which will have a breaker to isolate the panel.
it also depends on what meter you have, is it a KWH METER or a AH METER. IF ITS A KWH METER(KILO WATT HOUR) IT COUNTS IN WATTS (35w PER HOUR.)
Disconnect the supply with the help of utilty personnel and then start lowering it.Please see that the cable/wires are sufficient for the new location.
Could be tricky. The business owner WILL need to give their written consent (since it's their building). However - you could contact the energy supplier and ask them for a separate meter. Assuming you rent a room(s) within the main building, the power company should be able to run a spur off the main supply cable for the building to provide your workspace with a separate meter.
14
It depends on the material of the cable (aluminum or copper) and the gauge of the cable. (Thickness). And on the current you intend it to carry.
1 meter = 100 centimetres
1000 1 meter = 1000 millimeters 1 millimeter = 0.001 meter