50 amp with AWG # 6 wire is normal. Read the instructions that came with the stove to make sure.
The 240 volt receptacle has to have an amperage rating. It is this rating that governs the wire size and breaker size to feed the circuit. The new two pole breaker will be inserted in the 100 amp distribution if space is available and connected to the new wiring that terminates at the new receptacle.
Yes you can but the electrical code does not require it. To use one where it is not requested to do so is just adding to the over all expense of the project.
AWG #3 copper.
In North America a two pole breaker will be used in the distribution panel for a supply of 240 volts for a 240 volt load.
A breaker is based on wire size, as the breaker protects the wire and not the load. This is a voltage drop question. A #3 copper conductor will limit the voltage drop to 3% or less when supplying 60 amps for 110 feet on a 110 volt system.
20 amp breaker 12 gauge wire assuming its 120 volt
Depends on the wire size used in the circuit. If you use AWG # 14 wire you must use a 15 amp breaker. If it is wired with AWG # 12 wire then you use a 20 amp breaker. If a AWG # 10 wire is used then a 30 amp breaker is required. The breaker protects the wiring from overheating so you must use the proper size breaker for the wire used.
15 amp
What size breakers are needed for a 30kva transformer 208 volt feed 600 volt out put
20 amp
50W@12V is 4.2 amps, so any breaker rated that or higher should work.
The formula you are looking for is I = W/E.
20 amp is perfect, 15 is fine
You will need a multimeter to check a 220 volt breaker. You should unplug appliances that go to that particular breaker. Use the multimeter at the breaker to check the voltage. If it shows 220, then the breaker is okay. If it doesn't, then the breaker is no good.
It's the amps that are controlled by the breaker not the volts. You can have a 600 volt 15 amp breaker, you can have a 347 volt 15 amp breaker. The breaker will trip when you exceed 15 AMPS.
The 240 volt receptacle has to have an amperage rating. It is this rating that governs the wire size and breaker size to feed the circuit. The new two pole breaker will be inserted in the 100 amp distribution if space is available and connected to the new wiring that terminates at the new receptacle.
Add 25% so it comes to 42 amps