Want this question answered?
hjnbvghvtycvfg yu fyd h u ydxtdfy6dyu rdft ydey
yes you can but, the compressor may not run as well and the capacitor may smoke and break if the compressor runs for an extended period of time so, make sure you check it the first couple of time you use the compressor.
$1.22
There are size on size weldolets. The hold on the run pipe will necessarily be undersize (either hot tap or torch ) because it's not possible to cut the same size hole in the run without damaging the base material.
It depends upon what kind of generator you are talking about. I would recommend reading the owner's manual to see if there is any limitation on how long it can be run continuously. You will probably have to stop it every so often for oil changes and whatever other routine maintenance is required. Your owner's manual should give you that information. Also it depends upon what is the demand for electricity and what other power sources are available.
The factors that determine how long a propane generator can run are the size of the propane tank, the size of the generator, the brand of generator, and what is being used under the generator's power.
You need a 5.5kw generator to run a 5.5kw motor.
Need to know the voltage of the motor to answer this queston.
Identify the neutral wire on the generator. This will be the unused conductor to run the compressor. The ground and line1, line 2 are all that are needed.
A 1500 watt generator will do fine.
The electrical code book states that a single phase 3 HP motor at 230 volts draws 17 amps. This equates to 3910 watts. Allowing for starting inrush current a 5000 watt generator will run the motor but the generator will labor a bit until the motor gets up to speed. Generators with a higher wattage rating would have less trouble with the starting of the 3 horse power motor. <<>> One hp is 746 watts. 3*746=2238. It takes 3 to 6 times as much energy to start as it does to run.
To answer this question the voltage and amperage of the unit must be stated. Once this is given the generator size can be calculated.
Check the wattage of the blow dryer and add 500 watt. This will be the size of generator you will need to use.
10kw
The sizing of the generator is dependant on the size of the electric motor driving the mixer.
If it is a portable generator the breaker should be self contained within the generators panel. If the generator is a stationary standby unit a voltage has to be stated to calculate the conductor size and hence the breaker size to protect the conductor. Amps = Watts/Volts.
You would do better looking on the compressor name tag than relying on an answer you`d get here.