0
For single phase 30 amps at 120 volts you would need a #8 copper wire with an insulation rating of 90 degrees C.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What wire size needed for 150 feet run on 30 amp?
This is a voltage drop question. To answer this question a voltage must be stated.
Is number 10 wire good for a 20 amp circuit that is 250 feet?
Assuming you are working with 120v, you need #4 AWG copper conductors.
What size tech cable for 480 feet 100 amp?
This is a voltage drop to establish wire size question. For a correct answer to this question two values are needed. One value needed is the voltage and the other is whether it is three phase or a single phase installation.
How is wire pulled into a conduit of 100 feet?
A 100 foot fish tape and wire lubrication will be needed to make this wire pull.
What wire size is needed for 15 volt circuit?
The wire size depends on how much current it will conduct.
What size wire is required for 120v 5amp 250ft?
Use AWG #10 wire on a 20 amp breaker.
What size wire needed for 25 amps 220 volts for 75 feet?
10 AWG in copper.
What size wire is needed for carrying 100 amps under ground?
To calculate the wire size, a system voltage is needed.
Should you Run a 20amp circuit 150 feet with?
If this question is asking about voltage drop, to size a wire, a voltage is needed.
What size wire do you need to feed a 5 amp load run 1500 feet from the main at 120v?
A #3 copper conductor will limit the voltage drop to 3% or less when supplying 5 amps for 1500 feet on a 120 volt system.
What wire size needed for 150 feet run on 30 amp?
This is a voltage drop question. To answer this question a voltage must be stated.
What do you have to know to install a 120v electrical line?
You know the old saying: "If you have to ask..."! If you're asking this question, you should probably be calling an electrician. The answer to your question depends upon what you are trying to power up. This will determine what size wire you will need and therefore, the size of the circuit needed.
Is number 10 wire good for a 20 amp circuit that is 250 feet?
Assuming you are working with 120v, you need #4 AWG copper conductors.
What size service underground wire for 60amp at60 feet?
# 6 copper wire.
What gage wire do you use for 15 amps 200 feet?
This is a voltage drop question. To answer this question a voltage has to be stated. The higher the voltage to the circuit becomes the smaller the wire size needed. After a certain voltage point the wire size will remain constant and the voltage drop at the load will become smaller.
What wire size is needed for 30amp load for 34 feet on 12 volts DC?
8 gauge will be sufficient with less than a half volt drop
What size wire is needed for a 180' run?
To answer this question the voltage and load amperage is needed.
