black should be your hot white your neautral and the red should be the interconnect to another smoke alarm so that if one goes off in the upstairs the down stairs one will go off also because they are joined by the red wire(interconnected) check for another smoke detector(the red/black/white)should be fed from it to were you are talking about
Install the GFCI outlet is a location near the hot tub where it can be accessed and tub plugged in. Connect ground wire to green ground screw. Connect black/white wires to LINE side of outlet. Black goes to copper screw, white goes to silver screw. You connect the wires by inserting them into the holes marked LINE and then tightening the screws down tight.
Black, red, white and green have been the standard colors for house wiring for quite a while. Your question needs to be a little more specific.
The new cooktop has a 4 wire connection. Red & Black are hot. White is neutral, and green is ground. You existing panel is wired with 3 wires. Black & Red are hot and green is ground. There is no neutral wire. Connect the black to black, red to red, and then connect the white and ground together at the plug.
Do you mean a 3 wire receptacle? You say cable,are you talking like extension cord type or interior romex wiring? If romex, you should have a black, white and bare(green or ground)and possibly a red if a 4 wire . Connect black to gold on the receptacle,white to silver and ground to the green screw.
If your house wiring is encased in armoured (metal) sheathing back to the panel, then you can secure the green ground to the ground screw in the box. Make sure the armoured cable connector is tight on the box. This should ground the light back to the panel. If you are on "knob & tube" I would suggest thinking about re-wiring the house.
green and black
red - brown black - blue green/yellow - green
Tie into existing wiring
Connect the green wire to the brown striped black wire.
Normally Red is the positive connection and Black or Green is negative.
green and black mate
On a 110 volt circuit, Black is hot, White is neutral, Green or bare Copper is ground. . Connect Black to the gold screw, White to the silver screw, and bare copper ground to the Green ground screw on the receptacle. On a 220 Volt circuit Black & Red are both hot, each carrying 110 volts for a total of 220. White is Neutral and ground is Green or bare copper.
lime green, black and yellow
red = phase, black = neutral, green = earth
Install the GFCI outlet is a location near the hot tub where it can be accessed and tub plugged in. Connect ground wire to green ground screw. Connect black/white wires to LINE side of outlet. Black goes to copper screw, white goes to silver screw. You connect the wires by inserting them into the holes marked LINE and then tightening the screws down tight.
Black, red, white and green have been the standard colors for house wiring for quite a while. Your question needs to be a little more specific.
The new cooktop has a 4 wire connection. Red & Black are hot. White is neutral, and green is ground. You existing panel is wired with 3 wires. Black & Red are hot and green is ground. There is no neutral wire. Connect the black to black, red to red, and then connect the white and ground together at the plug.