no way, car rear ends are alot smaller then truck rear ends. it will not work.
depends if you are talking about the whole rear end or just the axles themselvs, and yes to both of them but if you take out 3/4 ton axles you will need 3/4 ton axles to put back in and so no. if you take the whole rear end of a 1/2 ton and put in a 3/4 ton rear end it should fit well
1X3 TON will take 12/14 cbm cargo if the cartons are semilar size
If they are both 10 bolt, which means that 10 bolts holding on the rear end cover, and have 8.5" diameter ring gear.
Yes you can, But the 308 ring and pinion will have to be for the 1982 carrier that's in it now.
In most cases you can fabricate to fit something, however it degrades the safety of the vehicle, plus the rear axle in the 85 Toyota in most cases is a 1/2 ton axle, What would be the purpose of putting in a 1 ton axle? Trying to increase payload or towing capability?
No, the 1500 is a 10 bolt rear end. The 2500 will be a 14 bolt either semi floating or full floating rear end. Also there is a different lugnut pattern 3/4 ton has 8 studs, 1/2 ton has only 6. Will it work? Most likely but it is defeating the purpose of the 3/4 ton frame.
IF it is a 1/2 ton truck then a 4l60E belongs in it from the factory. IF it is a 3/4 ton truck then a 4l80E was factory in it.
If the 1989 1 ton was a 4 door, it should fit as they are the same body style. They didn't change the 3/4 ton and 1 ton truck bodies til later.
6 refrigerators
Please, just use the manufacturer intended wheels on your car.
3500 series is a ton truck.