answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Working clearance from a transfer switch to gas meter?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What can you put on your house meter to stop a generator from energizing a grid line?

A double pole double throw transfer switch is what you are referring to. It does not go on the house meter. The placement of the transfer switch is between the first over current device and the distribution panel.


What is the Phase to phase clearance for 33KV sub station?

1.2 meter


How do you bypass an electric meter?

There is no need to bypass the utility meter. In order to use power generated on site, you need to install what is called a transfer switch. The transfer switch selects either utility power (that comes through the meter), or site generated power, but never both at the same time. You then wire branch circuits from the transfer switch to the various lights, receptacles, etc. you want to power. You can buy transfer switches that have from one to 20 or more circuit breaker positions to do this.Never, ever wire site generated power directly to utility-fed circuits!This can cause severe damage, as well as hurt or kill people. If there is a power outage, and you are running your generator (or whatever), you can backfeed power onto the utility lines. The workers trying to fix the outage, can come in contact with the lines, thinking they are dead, not realizing you are backfeeding power to them. Be safe, use a transfer switch!IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOBSAFELY AND COMPETENTLYREFER THIS WORK TO QUALIFIED PROFESSIONALS.If you do this work yourself, always turn off the powerat the breaker box/fuse panel BEFORE you attempt to do any work AND always use a meter or voltage indicatorto insure the circuit is, in fact, de-energized.


How do you get the lower 2 brake lights on a 1999 Chevy cavalier working when it is not the bulbs or brake switch?

If you're positive it's not the bulbs (you know this because you checked them with a meter or tested the outlet with a test light maybe) or switch, check it out for a bad ground.


What is a magnetic clutch switch?

its a clutch stuck to a switch and it can carry magnetic stuff near 1 meter away


How do you check a brake switch How do you know if its bad?

Put a test light or a an ohm meter between the two leads. Push in or out depending on what kind of brake switch you have. If the ohm meter shows continuity or the test light lights up the switch is all right.


What is the working principle of a q-meter?

Q-meter works on the principle of Series Resonance


What would be the problem in Honda civic sedan 2001 if the speedo meter lights are not working?

Some bulbs may be burned out, or a blown fuse or the dash light dimmer/brightness control switch is turned off.


What is the Working principle of taung tester clamp meter?

CLAMP METER WORKS WITH THE PRINCIPLE OF HALL EFFECT..


How do you test Window switch to see if defective?

if you have a meter,, disconnect the wires going to the switch , put one lead on each side of the switch and move the switch ,, have the meter set in Ohm mode, if it moves , the switch is ok, if it stays at 0 ,, its done ( hint, tap the back of it lightly if its dead,, it may have fused together and sometimes this will break it loose)


Who would you contact regarding parking meter keys?

You should contact the transportation department for the city where the parking meter is located. They will be able to transfer you to the parking authority, who should have the keys to the parking meter.


Your car Hyundai 2005 alenta rmp meter some time work some time not working . how i can fix.?

what cause rmp meter some time work some time not working