The VOM (Volt-Ohm Meter) is type of measuring equipment used for reading the three major properties of electricity which are the Voltage, Current and Resistance. This tool typically has a huge rotating knob on the middle part which allows you to select the type of electrical property that you would like to measure. At the bottom part are the two probes differentiated with Red and Black color. The Red probe denotes the positive terminal while Black for the negative terminal.
Now, you might be wondering about the other smaller rotating knob just above the huge selector which is labeled as Zero Ohm. This adjusting knob only concerns about resistance. It doesn't have any effect when the primary selector is set for Voltage and Current.
Chat with our AI personalities
Ohm's law is the basic answer. Voltage = Current * Resistance is ohms law. In order to find current divide voltage by Resistance V/R=I where I is current.
Algebra is one of the most fundamental tools for engineers (and physicists) because it allows them to determine the value of something (length, material constant, temperature, mass, and so on....) given values that they do know (possibly other length, material properties, mass......).Although the types of problems that different types of engineers (mechanical, chemical, civil, environmental) deal with varies a lot, all engineers use algebra to solve problems. Mechanical engineers, for example, will usually use calculus to determine the dimensions a certain part may need to be, but in situations where things are constant, it is much faster to simply use algebra. For example, in a situation where there is constant acceleration (due to something simple like gravity) and an object with constant mass, newton's 2nd law (Force = mass * acceleration) may be quickly used to determine the force associated. In most situations, however, the acceleration will not be constant, so calculus will need to be used.Another example of where algebra is frequently used is in simple electrical circuits, where the resistance is "ohmic", or linearly proportional to voltage. Using "Ohm's Law," or V=IR, an engineer may simply divide the voltage of a circuit by the current that they desire (for whatever reason) to determine the type of resistor they should put in the circuit.UNICORNS AND GIRAFFES ARE AWESOME!!!!!!!!!!!!!!!!!!!!!!! B]