50 x 7 = 350m
isolate the variable
Being and Not Being.
Yes, a colon can be used before a quotation if the preceding sentence is an independent clause that sets up the quotation. For example: She said this about the project: "We need to focus on quality." However, if the quotation is integrated into the sentence without being preceded by an independent clause, a colon is not necessary.
Stop being nasty stop being nasty mr.brown
120 Consider: You know that the supplement of an angle is equal to 180 minus the angle. You also know that an angle is twice it's supplement. Now, if you think of angle as being "A", and it's supplement being "S", then we can re-express the above statements like so: S = 180 - A A = 2S Then logically, we can replace the "S" in the second equation with the value we have for it in the first one: A = 2( 180 - A) and then solve that equation: ∴ A = 360 - 2A ∴ A + 2A = 360 ∴ 3A = 360 ∴ A = 360/3 ∴ A = 120
Assuming (1) the object starts from rest, (2) air resistance is insignificant, the object speeds up by about 9.8 meters/second every second. That's the strength of the gravitational field. Just multiply this acceleration (9.8 meters/second2) by the time.
19.64 MPH. At that pace it would take 183.30 seconds to run one mile. There being 3600 seconds in an hour, dividing 183.30 into 3600 gives you 19.64. 200 meters divided by 22.78 seconds = 8.78 meters per second 8.76 meters per second x 3600 seconds per hour = 31 607 meters per hour 31 607 meters per hour divided by 1 609.344 meters per mile = 19.64 miles per hour
Speed in physics is called velocity what you are looking for when you are talking about speed/velocity you are looking for an answer with the units being "distance/time" such as "miles/hour" in this case you are using the distance measurement of meters and the time unit of seconds therefore you want an answer in "meters/second." Ergo, you divide the unit of distance by time so it would be "45 meters/5 seconds" which would simplify to "9 meters/second" where the symbol "/" can be pronounce as "per" so it could be written "9 meters per second" I hope you did just get the answer, but rather some of the thought process of the issue.
In a vacuum, the instantaneous speed of an object 2 seconds after being dropped would be approximately 19.6 m/s, as the acceleration due to gravity is 9.8 m/s^2 and the object would have been accelerating for 2 seconds.
The velocity of a freely falling object 5 seconds after being dropped is approximately 49 meters per second (m/s) downwards. This is the velocity an object reaches due to the acceleration of gravity (9.8 m/s^2) acting on it.
Use the formula a = v2 / r, with v = velocity (speed, actually) in meters/second, r = radius in meters. The answer will be in meters per square second.
One microsecond is one one-millionth of a second, or 0.000001 seconds. Being that it is considerably shorter than a second, the length of a second cannot be contained within this span of time.
Well we all know that the Human Population is still growing. Well for every 7 seconds and human being is born and for about every 12 seconds a human being dies.
In latitude, 1 second is equivalent to roughly 30.8 meters. In latitude, 1 second is equivalent to roughly 30.8 meters along the equator, and it shrinks steadily to zero at the poles. In general, it's 30.8 meters multiplied by the cosine of the latitude where it's being measured.
1 foot = 0.3048 meter 1 minute = 60 seconds60 feet/minute x 1 minute/60seconds x 0.3048 meter/foot= 0.3048 meter/secondyou may try using the online converter linked below next time.
Square seconds, by itself, doesn't make much sense. On the other hand, please note that acceleration is not the same as speed or velocity, therefore you would expect the units to be different between the two. Speed or velocity is measured in meters / second; since acceleration is the change of rate of a velocity (in symbols: dv/dt), its units are velocity / time. Using SI units, that would be (meters / second) / second, and this is commonly written as meters / second2, which makes sense since the seconds appear twice in the denominator.
A container being filled at 0.8m3 per second will fill 12513m3 in 15641.25 Seconds or 4 Hours, 19 Minutes, and 58 Seconds.