It is a ray.
It depends on where you start and which direction you move.If you start at zero and count up, then the square of 17 will bethe 17th square number you'll encounter.That's 289.
assuming they start at the same point it would take 6 hours to accumulate 180 miles betweenst them. If however they do not travel in a straight line (such as the surface of our planet) it would actually take just a bit longer because of the curved path of each traveller
Describing the process in words is much more difficult than doing it. So I suggest you sketch out the steps as described. It will be much clearer that way! 1. Start with a straight East-West line. 2. Draw a line perpendicular to it - this will be North-South. 3. Now bisect the angle between West and South. This line will run from the centre to the SouthWest! 4. The angle between the line going East and this last line is 225 degrees.
First start out by writing an equation in point-slope form because you have a slope and points. So, it will be:y+3=-2(x-1) use distributive propertyy+3=-2x+2 subtract 3 on both sides to get y aloney=-2x-1 answerThe answer is y=-2x-1
y=2X+2 y=mX+b b = y intercept. This means the intercept of this graph is 2. plot a point at (0,2) this is where the graph starts m = slope. so the slope of this line is 2. start at the point (0,2) and count up 2 units, over 1. up two, over one. then connect the dots, and there ya go! :)
lines go forever in both directions rays start at a specific point and go forever in only one direction
a line. starting from one point and going on as long as it needs to go on. or it could go on forever. it needs a start and a finish...
A ray ends from one point and goes on forever in one direction. .------------------------> Except the point is connected to the line. It sort of looks like that Examples of real life rays are rare, because how many things start at one point and go on forever? Rays are used primarily for mathematical purposes.
that is woijnjc
yes
To draw a ray in a geometric figure, start by drawing a straight line. Then, draw a point on one end of the line to represent the starting point of the ray. Finally, draw an arrow on the other end of the line to show the direction the ray extends infinitely.
A line is a one-dimensional set of points that extends to infinity in both directions (so it has no endpoint). A ray is a line that goes to infinity in only one direction and has one endpoint. A line segment is a line with two endpoints (so it does not go to infinity).
Ray, it has a stop/start point (the flashlight), and it goes on "forever."
The difference is that lines go on forever and line segments start at a certain point and ends at a certain point.
The slope of a distance-time graph represents the direction of motion. A positive slope indicates motion in the positive direction, while a negative slope indicates motion in the negative direction. A horizontal line represents no motion.
Parallel lines--will never touch Perpendicular lines--cross at right angles Rays--lines that start at a point and extend into infinity Line segment--a line between two points Line--a line that runs forever in either direction
Start with a point, then draw a line along with the dot with arrow pointing at whatever direction you want to