So it doesnt look like a 1.
No, but a line segment does line segment:._____________________. line:___________________________________________________________etc.
First make the number line by drawing a horizontal line with an arrow at each end. Then put 7 or more evenly-spaced, vertical hatch marks ( very short vertical lines that extend about 1/8" above and below the horizontal line). Below the rightmost hatch mark put 0 (zero) , and then put the 6 negative numbers below the hatch marks to the left of zero. Put dots on the number line where the hatch marks for -5 and -6 cross it.
Between 1 and 2
in between 1.5 and 2 you make a point for 1.8
The formula for slope by two points is: (y2-y1)/(x2-x1). More simply put, rise over run: The increase or decrease in height divided by the distance moved to the right.
To put a fishing hook on a fishing line, first thread the line through the eye of the hook. Then, make a loop with the line and pass the hook through the loop. Pull the line tight to secure the hook in place.
1) draw a circle 2) put on line from bottom of circle 3) put horizontal line through line as long as the other one 3) from bottom of vertical line put two lines 90
<s> put your writing in here </s> hope this helped :)
The rings on the rod that the fly line is put through.
When it was discovered by Europeans.
tally
To put a bobber on a fishing line, first thread the line through the top and bottom holes of the bobber. Then, slide the bobber up the line to the desired depth and secure it in place with a small knot or a rubber bobber stopper.
To put a hook on a fishing line, first thread the line through the eye of the hook. Then, tie a secure knot such as an improved clinch knot or a Palomar knot. Trim any excess line and ensure the knot is tight.
The mohawks got treated like garbage when the europeans came because the europeans kept on buying their land and put them on a reserve
well the answer i put was the equator
I can't seam to get the holes to line up to put the nut & bolt through
Are both sides the same. When you put a line going through the middle, are both sides the same or are they different.